Nissan Frontier 4x4 crewcab supercharged. P0340. won't start. also p0325 power to distributor, no spark, resistor ok, coil resistance ok, distributor checks out ok on scope. P0340....Camshaft Position
Question about 2000 Frontier
2000 Nissan frontier 3.3 My truck just died on me 2 minutes after I cranked it on the morning.Already changed the distributor and the fuel pump. Can anybody give me an advice I'm so confused about it?
...frontier that the code shows it needs a knock sensor or a crankshaft sensor. Is there anyway I can tell the sensor I need without buying both. Truck will not even start. The knock sensor won't make ...
2000 nissan frontier knock sensor code & distributor would the distributor have anything to do with the knock sensor code on a 2000 Nissan frontier?? no but the knock sensor does send a signal the
2000 nissan frontier 6cyl 3.3l will not start. pretty sure it is either the crankshaft position sensor or camshaft position sensor. since the truck wont start and I dont have an obd scanner I can't ...
...2000 Nissan frontier V6, 3.3L 4x4 crew cab You don't hear it running when your turn the key on just before the crank position. You have replaced the fuel filter and it was pretty much stopped up. ...
...2000 nissan frontier 3.3 4X4. Hello shalom570, The crank position sensor is on the rear left-hand side(drivers side) of the engine. See image below. To replace follow steps outlined below. 1. ...
nissan frontier codes p1444,p0120,p1320 truck runs good when first started but as soon it gets hot it stalls and shuts off and wont turn on Depending on the year up to 04, crank sensor goes bad and it
Question about 2000 Frontier
2000. Nissan frontier. V6. P335 trouble code won't go away crank position sensor 2000. Nissan frontier. V6. P335 trouble code won't go away crank position sensor If you have replaced the ...
Question about 2000 Frontier
...2000 Nissan frontier with a v6 I have crank. Position sensor code I changed the sensor but I still have the code How. Much voltage should I have at plug and when There is a crank and a camshaft ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions