2000 GMC Jimmy will not start Fuel pressure regulator changed, ecm changed, fuel pump working, fuses checked. Truck engine will try to turn over, sometimes it will start, but only after trying several
...2000 jimmy I just had a new enginge put in after the last one lost oil pressure now it is happening again. I do not know your model of vehicle. But low oil pressure is usually an oil pump problem. If ...
...Jimmy. If the engine is fireing I would rule out the coil for now. What you are describing sounds to me like low fuel pressure, if the pressure is not around 60 PSI then the injectors will not ...
...Jimmy started. Why? The first thing you should do is to locate the oil pressure switch/sending unit. It's a single wire terminal with plastic connect sensor from the engine block. This switch serves ...
how do you replace a fuel pressure regulator on a 2000 GMC Jimmy, 4wd. it is located inside the manifold,
where exactly is the oil pressure switch located on the 2001 GMC Jimmy 4.3l V-6 vortec motor? just to the right of the base of the distributor. right being facing the engine.
...the oil pressure switch is located in a 01 GMC Jimmy Hello janczuk69, Below is an image showing the oil pressure switch at location number 5 below the distributor. I hope this helps. Regards, ...
...oil pressure switch located at on a 96 jimmy 4.3 v6 you will see three wires leading to that switch on the side of the engine block. This switch has a black colored top to it where the plug in fits ...
...where the location is for a oil pressure sensor for a 1997 gmc jimmy v6 4.3l vortec engine? GMC Jimmy v6 4.3L has the oil pressure sensor on the back of the block near the distributor at driver
Question about 2000 Jimmy
...2000 GMC jimmy 2wheel dive I need Fram XG3980 oil filter so can this one work? I would use recommended filter pressure could be different and could possibly cause an issue not to mention filter media ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions