Question about 2000 Windstar
...2000 ford windstar 3.8 if i have right cylinder have replaced plug and wire and still getting cylinder one misfire #1 plug is the 1st plug on passenger side by firewall I have a 1996 ford wind star ...
2000 ford winstar sel update to problem code p0305,cylinder 5 misfire detected,p0303 cylinder 3 misfire deteced p0174 bank 2 system too lean not sure what i'm looking for to fix thanks again i had ...
how do i fix a misfire in a 2000 ford windstar The most common way to fix it is to do a tuneup, use a fuel system cleaner in the gas tank, and pull trouble codes from the computer to fix bad sensors.
cyl #2 misfire changed plus and wires no difference will coil only make one cyl misfire you have two wires crossed up ,check the firing order and see which two are crossed up ,hope this helped ,thanks
2000 Ford Windstar 3.8L error P0401 then P0404 2000 Ford Windstar 3.8L error code P0401 (in warmer weather) 2 mos ago & no problem noticed. Now Error P0404 in cooler weather and is surging, ...
...2000 windstar has a misfire it feels like it my 2000 windstar has a misfire it feels like it will stall at a stop sometimes wants to take off when just putting into drive or reverse changed the mass ...
Question about 2000 Windstar
2000 ford windstar shakes only when accelerating and sometimes at stops. no cel codes Have it checked for stored codes, with a professionalscan toolYou don't need MIL Lamp lite on dash, to have ...
Question about 2000 Windstar
...Ford Windstar Van. Any advice would be greatly appreciated. If it is the distributor style, I would be chasing the Distributer cap and rotor button Hi Jimmy, swap the spark plug and the wire, if no ...
Question about 2000 Windstar
...2000 ford windstar 3.8 im having truble with cylinder#5 it has a new spark plug and a new fuel injector it has a new spark plug and a new fuel injector and its still misfiring Is it a plug wire or ...
Question about 2000 Windstar
...2000 Ford Windstar 3.8l Sounds like there could be carbon on the valve and not allowing the valve to go shut after firing. There is treatment you can buy to clear the carbon.Then reset the computer ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions