Replacing spark plugs I can't seem to remove spark plug wires on my 2000 ford ranger. grip the wires at the bottom near the spark plugs and turn left and right while gently pulling outward
Question about 2000 Ranger SuperCab
2000 ford range When I go to turn the wheel in my 2000 ford ranger I hear loud squealing noises. I checked the power steering fluid and its full. What can it be? It sounds like the power steering belt
2000 ford ranger super cab won't start clicking 2000 ford ranger V6 super cab won't start clicking noise under dash. no electrical to anything. switched the main fuse just off the positive battery ...
2000 Ford Ranger will not start, has new battery, however will not turn over, what are some common problems and solutions? lost the chip out of the key ,try the spare ,if that doesnt work call the ...
2000 Ford Ranger. No power anywhere, new battery 2000 Ford Ranger XLT 4-cyl. No power anywhere, got a new battery; then the dome lght and everything worked. Turned the key and instantly got a click ...
...2000 Ford Ranger. Went to a bank, did my banking got back-in the truck and all I got when the key was turned was...click. Sorry need more than that but, This could be many of things most likely dead ...
Question about 2000 Ranger SuperCab
...2000 ford ranger bucks at speeds of 45 and 50 going up hill Yea! I'd like to see the answer to this also! My Ford Explorer 2000 does the same thing going up hill. Especially with a loaded trailer ...
Question about 2000 Ranger SuperCab
...system on a 2000 ford ranger ext cab 2wd with 3.0 v6. Just replaced the motor All lights work. Turn key to start and nothing not even a click. Yes Take it to the dealership. They will get you fixed ...
Question about 2000 Ranger SuperCab
what vehicles will interchange parts with a 2000 ford ranger xlt 4.0? I am needing a radiator, mass air flow sensor and the turn signal switch. Will be needing body parts later. ford explorer
Question about 2000 Ranger SuperCab
...2000 Ford Ranger XLT 4x4 with a manual transmission are as follows: Step 1: Tighten the bolts to 15 foot-pounds of torque. Step 2: Tighten the bolts to 30 foot-pounds of torque. Step 3: Tighten the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions