...1999 Jeep XJ 4.0L to repair a bad head gasket. My question is there a special socket or wrench to remove the head bolts ? Help !!!!!!!!!!!!!!!!!!!!!!!!!!!! no there should not be a specialty socket ...
cherokee 4.0L intake/exh manifold If you run around 30ft/lb it will be ok.Start from the middle and work outward in the tightening of the manifolds.The bolts need to have an anti-seeze on the them and
intake manifold? I have a 96 grand cherokee v8, unable to replace the thermostat housing to the manifold because one of the screw holes cracked off on the manifold. Position The Intake Manifold Gasket
...jeep cherokee intake manifold Intake manifold using new gaskets. Torque the bolts, in sequence, to 105 inch lbs. (12 Nm)... Fig. Intake manifold torque sequence-3.7 & 4.7L engines Hope this help ...
intake manifold bolt pattern 1999 jimmy 4 by 4 i replaced the intake gasket my son did not use a bolt pattern o a tork wrench it leaks at the back under side Remove the manifold add sealant to both ...
...jeep grandcherokee 4.7 L 8 cylinder On 4.7L the MAP sensor is located on the front of the intake manifold. An O-ring seals the sensor to the intake manifold. (click over image for zoom) Disconnect ...
1999 5.7 2 pc intake Apply sealer to the lower intake manifold bolts prior to installation. On the 5.0L and 5.7L engines, install the bolts and torque in sequence as follows: Step 1:
...jeep 4.0 back fries from intake Your headers(Intake manifold) gasket is worn maybe you are missing a bolt or you may have a cracked manifold. it usually means an intake valve isn't sealing. check to ...
Question about 1999 Grand Cherokee
1999 Jeep Grand cherokee Limited, 5.9 liter torque setting for head bolts need torque setting for head bolts. what else should I ask for. my request is self explained. torque settings for head bolts ...
Question about 1999 Cherokee
...1999 Jeep Cherokee 4.0? Head bolt pattern 4.0 - Jeep Cherokee Forum https://www.cherokeeforum.com > head-bolt-pattern-4-... Apr 12, 2017 - step 4...tighten all bolts except #11 to 110ft/lbs, then ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions