1999, p1309 , theresa for which code you want for you car model given by you. you have to specify you requirements totaly, THNX P1309 is a code that occurs when the PCM diables the misfire counter due
...1999 avenger with a 2.0l engine, for an oil leak and got this code, cleared it and the code came back. The code reader reads ignition control or misfire problem. Could this be a defective aftermarket ...
1999 intrepid will start fine and run ok then will stall. Wont start for a while sometimes for a couple of hours. Is it the ignition switch, starter, cam sensor, or crank sensor? problem is absolutely
1999 ford windstar has a p01309 code. what's the fix to make the code go away? thanks The code means that there's too much variance in the speed of the firing of the cylinders and therefore the ...
...on my 1999 saturn SL1, single cam 1.9 litter engine, but can't locate were they are at on the car. I think it's behind the motor inthe middle of the block. A crank sensor can set a cam code
...sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends to crank and cam sensors sounds ike it could be the ...
...1999 V70 WAGON AND THE ENGINE MANAGEMENT LIGHT IS STAYING MY MECHANIC REPLACED THE CAM ANGLE SENSOR BUT THE LIGHT IS BACK ON IT HAS BEEN SUGGESTED THAT IT COULD BE THE OXYGEN SENSOR After your ...
Question about 2001 F150 Styleside SuperCrew
...1999 ford explorer and the check engine light came on. I used my code checker and discovered the cam sensor was bad. After replacing the cam sensor and the synchronizer it cured the problem. But now ...
Question about 1999 Grand Cherokee
1999 jeep grand cherokee laredo just stops while driving Does it stall at idle or going down the highway? Does it restart right away? How long since a tune-up? Are there any applicable trouble codes? ...
Question about 1999 Grand Cherokee
...crown Victoria p71 cam shaft sensor located and it's this the same as a crank position sender??.. Need help What's that code ? P0071 ? A 1999 doesn't have a cam sensor , can't set code P0071 . Po171
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions