Questions & Answers for: 1998 ford contour speed sensor

1998 Contour Speedometer, gas gage, odometer not working Had a new timing chain installed and shortly afterward, speedometer, odometer, and gas gage quit working. Fuses have been checked but all fuses

Ad

...the speed sensor on a 98 Ford Contour lx auto trans 4 cyl 2.0 i think the vechile speed sensor on is located on the bottom left side of your transmission mounted on tranny at end of speedometer

Ad

Question about 1998 Contour

1 Answer

by step instructions on where is the vehicle speed sensor on a 1999 ford contour with a 2.5L engine On the lower rear of transaxle, will have three wires and either a rectangle or triangle shaped plug

Question about 1998 Contour

1 Answer

1998 FORD CONTOUR CHECK ENGINE CODES P1131 AND PO171. REPLACED 1 OF THE OXYGEN SENSORS, CHANGED PLUGS, PLUG WIRES, OIL AND FILTER, ALSO REPLACED AIR FILTER AND CLEANED PCV FILTER, RESET PC AND IT RAN ...

Question about 1998 Contour

1 Answer

not working there is to possibilities to this one is the instrument panel its self the other and less expensive is the transmission speed sensor on transmission the gear fails on the end of the sensor

1998 ford contour speedometer and odometer stop working everything else is find car runs great i been seeing codes 1380,1381, and 1383 i can get the 1381 and 1383 to clear but the 1380 is solid i ...

Question about 1998 Contour

1 Answer

...speed. Where is the temp sensor located? The sensor is the same one that tells the computer what the engine temp is. If the sensor fails, the check engine light should be on. The sensor is near the ...

...1998 Ford Contour it started acting funny. It would rev up high & stutter.Then it speed stopped.A few times I could get it going ok but very shortly the same thing. Is this my transmission? sounds ...

...1998 ford contour? the speedometer was working, i had jack the right front wheel up of the ground and start the car and put the shift lever in drive and speed the engine up to 60 MPH and then i let ...

do i need to reset anything after i replace the tranmission speed sensor on a 1998 ford contour 2.0l? Only any codes generated when it wasn't working properly.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...