...ball joint press, u also need a good 2 ton floor jack and a wide assortment of hand tools and a good dead blow hammer, the ball joint press alone can cost $75-200 and the others tools are not cheap ...
...ball joints on 1997. Is it hard to do yourself? How long does it take? upper ball joints are really easy, but you can't buy them without the a-arm, I just did one if the a-arm bushings are ok, just ...
Question about 1997 Town & Country
...1997 Town & Coun I ahve a 1997 Town & country mini van that has developed a front end shake and shimmy that only occurs when I accelerate. If I let off the throttle the shake and shimmy stops. I just ...
...ball joint This cannot be safely explained on FixYa. Solution: Go to the "Reference section" in your public library and locate the Chilton's or Motor's manual for your vehicle. They contain ...
what is the ball joint by the tire called? It's call a ball joint, you have an upper and a lower ball joint. If it has struts then you only have a lower ball joint.
ball joints (everything but tie rods) $1200.00. Mine is a 1997 Towncar. The tie rods were fine. I also put Michelins back on the car and it changed the ride to almost new and also takes the strain off
Question about 1997 Town Car
1997 Chrysler Town & Country LXI 3.8 and recently when I'm driving or even just getting in or out of my van all I can hear is a really bad creaking sound coming from the front right side of my
Question about 1997 Town & Country
...1997 Chrysler Town & Country LXI 3.8 and recently when I'm driving or even just getting in or out of my van all I can hear is a really bad creaking sound coming from the front right side ...
...BALL JOINT AND YOU WILL SEE LITTLE PUSH CLIP HOLES IN THE INNER FENDER IF THEY ARE MISSING SO NOW IF THIS IS THE CASE YOU WILL REMEMBER GOING TO THE CAR WASH OR DRIVING IN THE RAIN AND IT HAPPENS THE ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions