Questions & Answers for: 1997 gmc sierra crank sensor

GMC Sierra rear brake pads The rear brake pads on my 1999 GMC Sierra will not fit in the caliper with the shims installed. Should I grind them to fit or install without the shims? make sure piston is ...

1997 GMC CRANKS NO START 97 4.3 CRANKS HAS FUEL PRESURE BUT NO SPARK NEW CPS,CAM SENSOR NEW MODGULE WIRES AND PLUGS AND CAP . BUT NO SPARK FROM THE COIL check the ecm fuse and power wire from starter

New guy here, I am hoping that someone can tell me or show me on a schematic where the crank sensor is on a 1997 gmc sierra 5.7L engine in distributor

1997 GMC Sierra K 1500 5.7L and I have replaced the crank shaft positioning sensor, throttle positioning sensor, rotoe, plus, wires and also the ECM, fuel filter air cleaner, ect....it starts and runs

...1997 gmc sierra 5.7liter 4x4 replaced coil and OK 1997 gmc sierra 5.7liter 4x4 replaced coil and ign module today. Still no spark Cap and rotor look ok to eye? Any ideas what could cause no spark? ...

...1997 Gmc Sierra 5.7 4x4. It has no spark. I replaced the coil and ign module today but still no spark. Tech suggested Crank shaft sensor? Truck was running then died going down road. (30kms after ...

gmc sierra 1997 motor 5.7 reemplace el sensor que va en el distribuidor y ahora no enciende que puedo hacer as I make time for the 1997 GMC Sierra engine 5.7 engine that will replace the sensor in the

...gmc sierra 1500 runs fine on flat ground but when i climb a hill it bogs right down and the check engine light flashes have not done anything yet do not know where to start i also get a misfire code ...

...1997 GMC Sierra truck, does not start. I have pressure in the fuel line and also sparks. Like I said I have make sure I have pressure in the fuel lines I checked to make sure I have sparks, check the ...

...1997 GMC Sierra K1500. What OEM plugs go where? Truck Cranks and all lights seem to be working, but won't start. 1997 Sierra K1500 put another 5.7 in it (came out of a 97 also). My dad started the ...