Questions & Answers for: 1996 jeep cherokee crank sensor

1996 jeep cherokee 4.0 litre petrol turns over but not start found no positive feed to crank sensor or distributer and injecters not pulsing after a while car started . feed returned (5 volts) can ...

1996 grande cherokee 4wd 6cyl. dies out while driving will catch up or cut off,will crank after sets awhile and runs fine for awhile.has back fired with flames from exhaust.replaced ign. ...

...1996 Jeep Cherokee Sport? You don't have one on there. Pump is turned on and off by the automatic shutdown relay and the pump relay. The crank sensor signal keeps it on. If the asd relay does not get ...

1996 Jeep Grand Cherokee. Had fuel pump replaced couple of months back. While driving over a bridge it just quit. It tries to turn over but will not start. No gages are working. What would be problem?

...position sensor located on a 1996 jeep cherokee 4.0 the camshaft position sensor is inside the distributor, the crank sensor is at rear of engine in bell housing above starter. see pic of sensor ...

...jeep cherokee classic 6 cyl.? Also does 2000 cherokee have inline fuel filter? TO REPLACE SPARK PLUGS YOU REMOVE COIL PACK MOUNTING BOLTS THEN REMOVE THE COIL PACK WITH BOOT OVER THE SPARK PLUG.YOU ...

...jeep cherokee sport Sensor is at the 11 o'clock position on the bellhousing even with the flywheel (looking from the rear) on the drivers side. The harness connector is near the master cylinder. (no ...

...Jeep will crank but will not start. A friend said it is the crank shaft position sensor.My problem is locating the sensor so I can replace it. Typically it is located at the bottom of the engine near ...

crank sensor where is crank sensor located double posted, and still no engine stated. nor VIN pretend you go tho the auto store , the gander at you and ask the vin or engine, displacement. and ...

...crank sensor? dies while driving. Leave it set for awhile and will restart. Checked an no spark. Could it be crank shaft sensor? Where is crank sensor located? Yes. When it dies and will not start ...