Questions & Answers for: 1996 chevy gear oil

...1996 Chevy blazer awd if you think it is the differental, remove the upper fill screw with a 1/2" ratchet, stick your pinky in, if you do not have fluid on ur pinky when you pull it out, you need to ...

...1996 Chevy Blazer do you need to have the transmission in gear? no it should be in park with the engine running on normal idel . for more information read the instruction on the tranny deep stick no ...

1996 Chevy Tahoe. It runs great no real issues. It doesn't over heat but when the weather is hot outside and we go for drives, once we slow down and the tahoe has to shift back up from like 1st to 2nd

...1996 Chevy tahoe it Starts and run fine, just doesnt want to shift in to 3rd or 4th gear? Check to make sure that the fluid level is correct. There are shift solenoids inside your transmission that ...

Chevy Cavalier gear shifter is really stiff going into each gear, why? If it's an automatic transmission.... Try a SMALL amount of light oil on the transmission shift selector on the transmission.

1996 chevy s10 4.3 . four wheel drive will not engage 4 will drive will not engage in low or high range In the front of it there is a gear box look and see if the oil is ok if the gear lever is stuck ...

...chevy cavalier just started shifting really hard in to each gear its a manual and every time i try to shift it grinds going into each gear and sometimes pops out of gear the car only has 76,000 miles ...

gear oil on the rear left side tire what should i do? First make sure its gear oil and not brake fluid. If gear oil the outer axle seal needs to be replaced. If brake fluid the wheel cylinder needs to

...1996 Chevy Corsica The car will not move when in any gear. Can not push it either..Was told that the front axle may be broken. How do I remove it? I question the statement that the axle may be broken ...

chevy k1500 4x4 5.0 put #1 plug on tdc put dist in want start.where is pre-drilled hole in distributor driven gear to align with painted mark To reset the dist. you need to put #1 cylinder on top dead