Questions & Answers for: 1995 blazer replacing blower motor

Question about 1995 Caprice Classic

1 Answer

...replacing blower motor resister do have any power on either wire going to the blower. the power runs from the fuse block through a relay, to the blower, to the resistor block and finally to the dash ...

Ad

Question about 1995 Dakota

1 Answer

...wrong with the fuse box. Heater blower motor resister is bad, or blower motor its self is bad. Run 12 volts from an outside sourse to blower motor, if it runs its resister if not its blower

Ad

...blower resister in 1995 nissan maxima where is the blower resister located in a 1995 nissan maxima so I can replace it ? find the wires coming out of the blower motor and they should go right to it.i ...

...blower motor is not working either because the blower motor is bad or the blower motor resistor is bad if you lost any speeds before this happend then you most likly have to replace the resistor this ...

...do I check it to see if it is the reason the blower motor doesn't work all the time? Heater relay is located on the passenger side fire wall.Most likely the blower motor will have to be

Question about 1997 Blazer

1 Answer

...blazer fan blower would not work on high speed. i replaced the switch, relay, resister, and the fuse. Now i have no air blowing at all. I had a similar thing happen with my 97 Blazer as well. I ...

Question about 1998 Blazer

1 Answer

heater Check fuse first, then blower resistor on plenum for continuity between resistive elements. Replace if no continuity. It should be on top of plenum about a handspan or two from the blower motor

...blazer. Any ideas? This would suggest a bushing on the shaft of the blower motor is worn and causing the motor to have to pull too much current to run properly. You should replace the blower ...

blazer 1995 If your 1995 Chevrolet Blazer shows code P19DA, it means that there is a signal problem between the fuel pump and the PCM. This may have happened because you have a burned fuel pump motor,

...blower motor resistor The resister puts current to the motor when you change speeds on switch so if you motor only work in one or two speeds you no the resister is bad if you put current direct to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...