Questions & Answers for: 1994 jeep grand cherokee 5

1994 Jeep Grand Cheroke engine dies every few miles My jeep dies as I am traveling dwn the road with no warning. It happens every time I drive it. Then after a few minutes, its starts up again. I have

Ad

Question about 1994 Grand Cherokee

1 Answer

...1994 Jeep Grand Cherokee Hello, I've been having problems with starting my jeep grand cherokee with a 4.0L. When I turn the key, the check engine light which normally comes on does not - sometimes if ...

Ad

...Jeep Grand Cherokee's from 1993 thru 2004. ~Stillin~ Wrong. The red square was unique to 1993 and early 1994 ZJs with the VIC. Chrysler offered an oil level sensor on both engines and due to a high ...

...1994 Jeep Grand cherokee laredo 4.0 2wd before 1996 they use onboard diagnosis system for jeep.when you turn on key you need to count check engine light blinks.here are codes taken from internet.11* ...

1994 Jeep Grand Cherokee 4.0 L starts and shuts back down in 3-5 seconds. Changed Crank position Sensor. Jeep started, ran for 10-20 minutes idling and then shut down. Tried to restart and it turns ...

Question about 1994 Grand Cherokee

2 Answers

1994 jeep 42re transmission shifting problem 1994 Jeep Grand Cherokee/ 4.0 / Automatic / 4x4 / 6 cyl / 42RE Transmission. I am new to this forum and I very much hope that somebody will have a useful ...

Question about 1994 Grand Cherokee

1 Answer

...5 seconds. no spark to 1 plug, or all plugs?????????????? have you discovered the ASD relay yet> this allows the engine to run for 2 seconds. 1: it never closes.? 2: its bad. 3: the 7 or 8 inputs ...

Question about 1994 Grand Cherokee

1 Answer

...1994 jeep laredo jeep wont start why not let the PCM tell you what sensor is bad. and do the spark test, x 4 x 6? ??? if spark is all bad. insert the diagnostic jumper wire. then key on, then crank ...

Question about 1994 Grand Cherokee

2 Answers

1994 jeep laredo jeep wont start keep it simple first disconnect coil wire from distributor leaving coil connected, put a screwdriver in wire place it away from fan or other moving parts such as belt

...PCM commanded it but it refused to do its job) 5: same ASD output fails. i commanded it but the relay is bad. dead. 6: Immoblizer active. (failing or bad key etc,) if the ASD drops driving or even ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...