Questions & Answers for: 1994 ford ranger 2 coolant

1994 ford ranger 2.3 liter 1994 ford ranger 2.3 liter has 2 coil packs and 8 plugs the intake coil wont fire and have replaced it and plugs and wires crank sensor or cam sensor ignition control mod is

...Ford Ranger 1994 Does anyone know or have a diagram to change the O2 sensors. I have changed one but I am sure that there are more than one as it is still running rough and miss firing. Thanks There ...

...1994 Ford Truck E150 1/2 ton Van 5.8L MFI 8cyl Temperature Switch is located: Front seating area, center, under engine cover, front driver side of intake manifold, mounted in engine block. The ECT ...

...Ford ranger 2002 2.3 just started to run hot Check cooling fan, cooling fan sensor, the sensor's relay if such, coolant level, coolant pump. Sorry for not being able to tell you where are these ...

...Ford Ranger starting problems I have a 94 Ford Ranger Splash 4.0 and it runs fine but in the morning it takes about 6-7 trys before it'll fire up then its fine untill i let it sit for more than 2-3 ...

1994 Ford Ranger 4l v6 overheating, i checked the hoses, the belt, the fan and topped up the coolant. i drove over some rough terrain last night and right after the temp gauge went red. Could be a ...

1994 Ford Ranger Super Cab MAF problems My 1994 Ford Ranger will NOT hardly run. Plugs, wires, O2 sensors, MAF sensor, fuel pump, and pressure regulator have been replaced. When I disconnect my MAF ...

1994 ford ranger 2.3 runs fine wont stay idling runs fine first start up wont stay idling Try TPS. Throttle positioning Sensor. This sets base idle. (Unless this model is too old for that sensor) ...

...Ford Ranger 2.3. Where is the location of the engine temperature sensor please? Question edited for clarity, make sentence and toss in some CAPS. Question moved to model category. The engine coolant ...