Question about 1995 Grand Cherokee
...jeep grand cherokee orvis 4.0 automatic transmission and the speedometer does not all ways work when I first use my jeep, then it will start working after a mile or two and it seem to be ok until it ...
1993 Jeep Grand Cherokee, V6. Oil Pressure Gauge Read High. 1993 Jeep Grand Cherokee, V6. On acceleration, 1) the pressure gauge shows high oil pressure and the needle pegged at the top, 2) the RPM is
Question about 1999 Grand Cherokee
1993 Jeep Grand Cherokee gas gauge reads empty but tank is full. I have a 1993 Jeep Grand Cherokee that the gas gauge reads empty but tank is full. It just stopped working on me last night. I ...
...1993 Jeep Grand I bought a 1993 Jeep Grand Cherokee from a friend and the transfer case was bad on it so they replaced that and after a few months she noticed the Speedometer no longer worked (didnt ...
1993 jeep grand cherokee laredo, straight 6 engine. rolls back at times when in park with ebrake on.. bought it used. has a SEVERE case of bouncing speedometer. It would appear the previous owner ...
...1993 jeep grand cherokee spedometor stopped working and rpms are high and fuel consumption is poor Time for a tune-up! Need to have it diagnosed thoroughly. Likely your speedometer not working is not ...
malfunctioning speedometer speedometer goes to 12 instead of 0 on idle 1. Reset the speedometer by trip button.2. Remove the cluster unit and adjust the needle to zero manually
Question about 2000 Grand Cherokee
...Jeep Grand Cherokee, the hands aren't spinning and is beneath the rubber peg speedometer isn't working Disconnect the posative terminal then touch the terminal to the posative a few times ...
Question about 1993 Grand Cherokee
...1993 jeep grand Cherokee limited when I drive my jeep ,does not show the speed in my speedometer In the old days speedometer use to have cable today's cars n trucks have a speedometer sensor on the ...
...Jeep Grand Cher Loredo. replaced speed sensor now speedometer needle on wrong side of pin. Tried holding in trip button & turn onto start not run. no luck you saying the needle jumped over the stop ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions