Geo metro timing Just rebuilt my 92 geo metro. Did not mark the ditributor before pulling it. Everything is electronic on the distributor and I am supposed jumper a plug but can't find a pic and don't
...1992 GEO 1 liter eng. I can't find any marks on the camshaft to aline on anything. I found a dot on the crankshaft pully. What do I set it on? Thanks for your help. ...
...geo metro 3 cyl need to know where crank timing mark is on block? The timing marks are as follows 1. there is a "V" on the cylinder head cover. 2. Timing mark on camshaft timing belt gear 3. "Arrow ...
geo metro engine the main bearing caps go on startine with #1 at the pully timing belt end of the engine with the arrow pointing in that direction. Then #2 and so on in the same manor. Hope this helps
...metro. L3,, 1.0 liter. It is having problems accelerating up to speed in all but 1st gear. It studders until 4000 rpm and then is fine. It is hard to start cold sometimes. the gas mileage has gone to ...
...1992 Geo metro 1.3L. I changed the waterpump on the car, now the timing is off an the car wont start. when you re-installed the timing belt did you make sure the timing marks were lined up ...
...metro timing marks alldata d o t c om , its all there for $15 same at Mitchell.but more bread. is it a 1L engine 3cylinder or the 4 cylinder ? timing marks are on the gear behind the harmonic ...
1992 geo metro? it pulls out. with fingers. i assume you found it, lacking the where, question/ page 13 here> it is. http://metroxfi.com/wp-content/uploads/2008/12/suzuki_swift_1992.pdf its in the"
Question about 1992 Metro
...1992 geo metro the 94 has a mark on the block for the bottom timing gear but the 92 does not have that mark need help please ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions