Questions & Answers for: 1991 buick park ave code

sensor in a 1991 buick park ave I have a 1991 buick century that keeps stalling but starts right back up but know it wont start at all It is in front of the radiator, right below the latch on the hood

...1991 buick park ave with air ride and i need new struts in rear but i wanna elimate it is that possible I have the same car, and not could not find non-air struts for the rear end....ended up ...

...1991 Buick Park Ave. climate control stopped working. Pulled codes 38 & 152 per self diagnostic procedure. What do these codes mean? IT MEANS U HAVE A LOW SYSTEM REFRIDGERENT CHARGE BECAUSE OF A ...

1991 buick park ave. security system set off, 1991 buick park ave. security system set off, i've only got one key and no remote. how do i disable/reset my factory alarm? Did you try the drivers door ...

...Buick Park Ave. 1991. Automatic trunck I have Buick Park Ave. 1991. Automatic trunck latch will not close trunk. It closes the truck but will not latch. There is a motor on the bottom latch that goes ...

...1991 buick park ave need the coil pack is the magnavox type. see the link ...

I have a 1991 buick park ave and it idles high when in park and when I'm driving Try replacing your throttle position sensora(TPS). Had the same problem with my 93 park avenue.

My 91 buick park ave cranks but does not want to start. Retrieve your obd codes. It sounds like your crankshaft position sensor.

Buick Park Ave code 42 "EST"? I am getting the fault codes 42 and 27 on my Buick. 27 being the 2nd gear switch nad 42 being the EST. My transmission has been tested and is working fine. Is it possible

where is the transmission lock solenoid located on my 1991 buick park ave MICHAEL, YOUR BUICK DEALER WOULD BE THE BEST PLACE TO FIND YOUR ANSWERS. STOP BY AND TALK TO THEM.THANKS