Questions & Answers for: 1990 geo prizm timing

...geo prizm into a 90 geo prizm body but now when ever the car is on the fan is always running is the wiring different or what could it be? I did the same thing and had the same problem. I believe I ...

...1990 geo aren't working. could it just be a bad fuse? since both went out at the same time? Chk. fuse, if its ok, than it could be the break light switch, witch is under dash and works off the break ...

...Geo Prizm? Remove all nessary parts to access cover. Remove cover. Line up the timing makrs before removing old belt if car is still in running condition. Loosen the belt tensioner and remove belt. ...

...1990 geo prizm it's not customary for the timing marks to be in the groove surfaces of a pulley. remove # 1 spark-plug. Remove fuel pump fuse to not allow engine to start. Plug spark plug hole with a ...

...1990 Geo Prizm w/ auto trans. Is it suppose to shift more than two times? And it will only shift into second if i manully shift it. The trans. has to warm up before it will even shift into second. ...

...popping the clutch sometimes it starts with the key but more times than not I am pushing to start it is a 1990 geo prizm base car you need to buy and install a new starter, your old one is going

...1990 geo prizm 1.6 l engine replaced timing belt and cant find timing marks Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, ...

1990 Geo Prizm with under 75,000 original miles on it, but the nagging question is does the timing belt need to be replaced to prevent engine damage if the belt were to break? It is in the hands of my

why is oil coming out around timing belt cover 1990 geo prizm why is oil leaking out of timing cover? cam and front crank seals.. sometimes the rocker cover gasket leaks in under there as well

...geo prizm will not apply until the pedal is all th way to the floor...I have fairly ne pads and rotors and the brakes have been bled. There are no leaks in the brake system...what should be my next ...