1989 Ford Bronco full size. Not getting any power to the fuel pump. Maybe a power with wiring. Hi..my name is Keith..and the 2 things that i know of...that will not let power go to the fuel pump is 1.
no turn signals it likley to be the flasher relay burned out or a fuse poped look at both
Ford Ranger For some reason my signal lights will only work if the hazard button is pushed down yet the hazard lights don't work at all. Any idea? The hazard switch , turn signal switch , wiper switch
...ford ranger will some times stall and not start back.You can turn key but fuel pump doesn't start but next day it may run fine I would suspect a bad eec relay. These used to go out commonly, and ...
location of fuel pump relay where is the location of the fuel pump relay/1989 ford ranger/2.3L engine It's on the right front fender relay block, furthest to the rear.
1989 ford ranger and my signals when i turn them on stay lit they dont blink what is the problem? What should i do? this sounds like the signal flasher is no good and needs replacing.its located under
Question about 1989 Ranger
1989 ford ranger ,inside the rightside of engine compartment under the fulesbox,i have three relays .What are these relays for. 1989 Ranger ,2.9L Will not start,Battery is good,But I have no power ...
1989 ford ranger starter relay Starter motor keeps cranking after engine starts Try quickly turning your key to the start position and back to the on/run position. Your truck is like mine, if you have
Question about 1989 Ranger
...ford ranger 14a320 diagram turn signal connector wire colors and ppin location Images for Turn signal harness 2002 ford ranger Ford explorer turn sinal problem got fixed - YouTube ? 3:23 ...
...Ford Ranger 2.3 engine flasher works. both turn signals quit at same time Diane, There are 2 separate flashers on your vehicle, one is for the emergency/4 way lights and one flasher is for the signal ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
