Questions & Answers for: 1988 nissan truck specs

what is timing spec for 1989 300zx non trubo 15 degrees before top dead center

1988 pathfinder eith 3.0 engine starts but will not idle. have done tune up. fuel pessure in specs. actually runs better with lower fuel pressue. any ideas? idle control valve (sensor)

nissan sentra GXEi 1.6 (1988 model) E16E engine, Southafrican built, coupe clutch plate gets damaged within a 2-3 months of replacement. this has happened on three occassions in success. the pedal ...

Hi I'd like to know what cranking compression to expect on an n13 1.6 Litre that's running OK. I have doubts about the accuracy of my new gauge. u can go chilton online for specs or ask a dealer

What is the gap setting for the contacts on a 1988 Nissan Vanette Z24 Please Full data http://www.motorpowerinc.com/specs/z24.html

Head torque specs for 93 Nissan atlas FD42 alloy head petrol engine then 65-70 lbs if a cast head then 80 or so ,if a turbo diesel then 110lbs

...settings and crank torque settings for a 1988 Nissan Langley Exa 1500. try WWW.Carfolio.com and see what you can find. They usually have all of the factory specs on everything. Very cool

...1988 nissan d21 fit 1994 d21 if both shifters r in the floor At www.reliable-store.com get complete guide on whether to repair or not, service it, and how to repair etc, along with wiring diagrams, ...

I need torque specs on a 1988 nissan d21 3.0 crank bolts Check out this site for your specs. http://www.championbrands.com/aera-torquespecs.pdf

Nissan Pathfinder was derived from the Hardbody Truck and started in the same model year with chassis code WD21. so AGAIN,what country is this 1989 and what engine is there, D21 list the parts are NOt