Questions & Answers for: 10 head gasket

...10 blazer vin w with a 4.3 l vortech its white smoking with loss of power and is missing very bad white smoke is caused by coolant mixing into your combustion camber which is burning through your ...

...head Fig. 10: Removing the cylinder head from the engine block Remove the head bolts. Lift the head off the engine and place it on a clean workbench. Remove the head gasket. To install: Thoroughly ...

...10 miles the next day and it wouldn't start back up. The dealership says it's either a blow head gasket or engine. If that's the case why no water or oil drip? how did it drive the 18ish miles after ...

head bolts except Nos. 8 and 10. Tighten the bolts in the sequence shown in the illustration to the following: Tighten bolts 1 through 10 in sequence to 22 ft. lbs. (30 Nm). Tighten bolts 1 through 10

...10 times, replacing the head gasket fixes it. I just did it myself for $35. Go to checker/autozone and get a head gasket (should just need the gasket and not the entire kit) and a tube of RTV silicon ...

head gasket located on a 1999 saturn sl 1 The head gasket is in between the cylinder head and the engine block. The sly has a single overhead cam engine. This head is know for being porus and allowing

...are the possible causes? very common is a leaking intake gasket they also blow head gaskets a intake gasket could make you oil look milky and a head gasket could blow steam out of the

how to replace head gasket first sorry but good luck. a s 10 blazer is a hard one to do the head gasket in

...head gasket failure. 9 out of 10 times this is the problem. Good part is you have to pull the intake to do a head gasket, so id pull off the intake first, its not that hard on this motor. If they are ...

...lug nuts by skipping one as you go around. 10mm bolts require about 10 pounds or less torque. You can go to youtube and search "Torque head Bolts". They have some good videos there. Hope this