Question about RCA L26WD26D 26 in. LCD TV

2 Answers

A reset switch?

Watching TV and it was like you pulled the cord from the wall. No lights no sound. Have tried to reboot. Any suggestions?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Just found one in the trash with the no turn on problem. Opened up the back and the fuse and first capacitor were blown. find the fuse and replace it. If your capacitor is also blown (black and crusty anywhere) grab a soldering iorn and replace that puppy!

Posted on Apr 29, 2012

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 30 Answers

Wait until the power comes back on? Plug the TV back in? The obvious solutions are usually the best.

Posted on Sep 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

LG 55LE5400 LED TV will power up, but only shows black screen with no picture and no sound. Any ideas?


Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electro-medical.blogspot.com/

In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here.

Jun 11, 2016 | LG 55LE5400 TV

1 Answer

Hi, i have a Panasonic viera tx-l47et5b and yesterday i was watching tv as normal and it just went off by itself since the green light is just flashing every time i switch it on there is no red light...


Try disconnecting all of your HDMI cables and plugging the power cord of the TV into another wall outlet. If this resolves the issue, you may have had a small power surge from either your wall outlet or one of your source devices. It is recommended to connect your TV to a surge protector if you haven't done so already.

Aug 14, 2013 | Panasonic Flat Panel Televisions

1 Answer

LG 32L4DS this is my TV... my wife was watching and the screen went black no picture no sound any suggestions or is it a recyclable?????


Tv now turn on,tv have power LED light indicator flashes?Tries tv unplug,replug it back like an hour later,the tv now,should resetting itself back to the factory setting.The tv should work now.Not,than the power supply board is dead.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Oct 25, 2010 | LG 32LC2R 32 in. HD-Ready LCD Television

1 Answer

When watching tv froze made very loud noise and would not turn off or any buttons on tv work. unplugged from wall and tv now just illuminates a white led light for the power instead of blue for on and...


The power supply board is dead.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Sep 14, 2010 | Proview PA40JK1A 40 in. LCD Television

1 Answer

I have a KDL46VL150 that has started cutting off after viewing for a while. The standby lights blink a sequence of 6 times. Usually if i unplug or cycle power to off and wait a bit it will return to normal...


It indicates that there is an internal malfunction within the TV. You can try Power reset.
To Reset the TV, please disconnect the power cord for a short period of time (approximately 1 minute). Then, reconnect the power cord and power on the TV.
You can also try connecting the TV directly to the wall outlet.
If the issue persists, I suggest that you get the TV serviced to fix the issue.

Jul 12, 2010 | Sony Bravia KDL-46V4100 46 in. LCD HDTV

1 Answer

On WGN HD, watching the Cubs game, the white color in the crowd and mortar in the brick walls pulsate. Very distracting.


just try to reset your LCD TV if reset button available there if not. The you unplug power cord for 4 hours then plug it again.

Good luck:

Regards:
VOTIT

Jul 08, 2009 | Philips 42PFL3603D/27 42 in. LCD TV

1 Answer

No Picture, No Sound While Watching


Resetting the TV
If the buttons on the remote AND the buttons on the TV case do not work (channels do not change and you cannot open or navigate the menu), the TV has stopped responding. Reset the TV as follows:

NOTE:
Some TVs have a reset button. If available and accessible, try using the reset buttons before using the steps below. Using the reset buttons can save time.
1. Unplug the TV power cord from the power outlet.
2. Unplug any connected devices (DVD, Set-top boxes, etc...)
3. Press and hold the TV power button for five seconds.
4. Plug the TV power cord back into the power outlet and turn on the TV.
5. Open the on-screen menu to confirm that the TV is responding again.
6. Turn off the TV and reconnect the devices.
7. Turn on the TV.



LCD TV TroubleshootingThe defective LCD TV may have the following common symptoms:

Symptom: No picture on screen but LCD TV still has sound.
Solutions: The problem is cause by defective inverter. Replacing ivnerter will solve hte problem. Symptom: Screen flash on and off between 1/2 to a few seconds, but power indicate light stays on and TV still has sound.
Solutions: The problem is cause by defective inverter. Symptom: Blue Screen but no picture
Solutions: The problem is cause by defective Main Board(AD Board). In some cases, this problem may cause by the defective Screen Controller board. Thsi board is mounting on teh back of LCD TV Scree. Symptom: Power light stays on but no display and sound
Solutions: The problem is cause by defective Main Board(AD Board) or Power supply board. Symptom: No Power or Power indicate light does not lits
Solutions: The problem could cause either by defective Power supply board or defective Main Board(AD Board). Symptom: Screen is half dim and half bright
Solutions: The problem is cause by defective LCD Panel.It needs to be replace.


Hope it may help you;

Regards;
VOTIT

Jan 29, 2009 | RCA L37WD250 37 in. LCD HDTV

1 Answer

Brand new LG plasma stuck on test screens


Resetting the TV
If the buttons on the remote AND the buttons on the TV case do not work (channels do not change and you cannot open or navigate the menu), the TV has stopped responding. Reset the TV as follows:

NOTE:
Some TVs have a reset button. If available and accessible, try using the reset buttons before using the steps below. Using the reset buttons can save time.
1. Unplug the TV power cord from the power outlet.
2. Unplug any connected devices (DVD, Set-top boxes, etc...)
3. Press and hold the TV power button for five seconds.
4. Plug the TV power cord back into the power outlet and turn on the TV.
5. Open the on-screen menu to confirm that the TV is responding again.
6. Turn off the TV and reconnect the devices.
7. Turn on the TV.

Hope it may help you;


Regards;
VOTIT

Jan 29, 2009 | Flat Panel Televisions

1 Answer

Sony KDF-E55A20 No picture or sound


The little flashing light down on front of your TV will tell you the problem by the color of the light or the blinking intervals, this is the reason you can not turn it off is telling you something. The manual should have a section dedicated to this part, most likely is the bulb, the bulb is easy to access generally hold by one or tow screws you can pull it out to verify the integrity of the bulb. Then again check the LED light before anything then you go from there.

Aug 28, 2007 | Sony KDF-E55A20 55 in. LCD Television

Not finding what you are looking for?
RCA L26WD26D 26 in. LCD TV Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Flat Panel Televisions Experts

The Knight
The Knight

Level 3 Expert

68352 Answers

Cindy Wells

Level 3 Expert

4759 Answers

Dave Naylor
Dave Naylor

Level 3 Expert

834 Answers

Are you a RCA Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...