Question about Sony KP-46WT520 46" Rear Projection HDTV-Ready Television

1 Answer

Sony KP 43ht20

I have the above mentioned TV The top 3 inches and the bottom 3 inches has a different color brightness, almost like the picture should be letterbox but I have it set to auto. I have tried to adjust the color and tint but cannot get rid of the border at the top and bottom. it is almost like the screen is dirty where the letter box would be.

Any suggestions would be appreciated
Rob

Posted by on

  • pgatoo Sep 05, 2008

    Thanks, is it worth fixing? Is that problem usually expensive?

    I will look for a good Tech that makes house calls, it is a big a@# TV! Thanks for your reply

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 125 Answers

There is a convergence problem inside the set you will need a good tech.

Posted on Sep 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The picture on our Sony TV Model KP-43HT20 recently became distorted, concaving at top and bottom. If I use reset the Flash Focus, the picture will return to full screen side for awhile but the colors do...


The tv have a problems known as a convergence problems,it dead.Tv have colors lines R,G,B mis alignments,have colors shadows pictures or 3D pictures look alike?The tv convergene board have dead 2 STK convergence ICS and some or all of it resistors are dead too.These parts on the tv convergence board,must be replaced to solved the tv convergence picture problems.The shop,will cost u like $300-350 for parts and labors.

Jan 15, 2011 | Sony KP-43HT20 43" Rear Projection...

1 Answer

The picture all of a sudden became blurred , color convergence is not aligned and there is a pink wave at the top left of the screen and a green wave at the bottom of the screen. When the color is adjusted...


Tv have convergence problems,it dead.Colors lines R,G,B don't aligned.The tv convergence board is dead.The 2 STK convergence ICS and some or all it resistors are dead,these parts must be replaced to solved the tv pictures covergence problems.The shop,will cost u $300-350 for parts and labors.

Sep 18, 2010 | Sony KP-43HT20 43" Rear Projection...

1 Answer

Colors don't line up, and screen is distorted on a sony KP43HT20


Problem #1) Convergence

Symptoms:
  • Screen Looks 3D
  • Colors wont align
  • Video may look distorted
Problem #2 CRT Fluid has clouded over. Symtoms
  • Dull looking video
  • White looking video
  • Halos around objects
  • Red/Orange looking video

You can see some examples and find a fix here...

bb0cf99.pnghttp://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull

Dec 08, 2009 | Sony KP-43HT20 43" Rear Projection...

1 Answer

Green hue on KP-43Ht20 Sony rear projection tv


Behind the front cover you will see a little plastic box with six phillips headed dials. They only move 180 degrees. The three on the bottom control color richness and the three above them control focus. Turn all three of the bottom ones to the left while the TV is on, then gradually turn them to the right until you get the color you want. NOTE if any one of the three bottom dials are too far up the TV will shut down and will continue to turn off after about 10 seconds after start up until the offending dial is turned back a little.

May 17, 2009 | Sony KP-43HT20 43" Rear Projection...

1 Answer

Sony KP-43HT20 Projection TV


5 times blinks is error code for No Good White Balance and you said that picture is very green.
As you know TV is approx 7 years old so it needs RGB gain adjustments.
If you are TV tech person or know about TV repair, let me know to guide you further. Or contact local TV repair shop to fix it.

Oct 26, 2008 | Sony KP-43HT20 43" Rear Projection...

1 Answer

Sony color rear video projector KP-43HT20


get the tv degaused that should fix the problem

Jul 23, 2008 | Sony KP-61V45 61" Rear Projection...

1 Answer

Blue and red color are off, picture is not clear


convergence amp ic bad
Sony Convergence
http://www.techlore.com/blog/entry/19694/Sony-Convergence-Repair-My-Sony-TV-has-a-distorted-picture-/
http://www.techlore.com/article/19631/Sony-Convergence-Procedure/

Jan 29, 2008 | Sony KP-43HT20 43" Rear Projection...

1 Answer

Sony KP-43HT20 convergence problem


Replace STK-392-110s or 150s upgrade with 180s replace both ics.

Jan 04, 2008 | Sony KP-43HT20 43" Rear Projection...

3 Answers

Sony KP-43HT20 ghosting effect.


may have bad convergence amps stk392-560 board location Ic8001 Ic8002 or the dcu unit is bad or the alignment drifted off and it needs service adjustments made to it.

Dec 28, 2006 | Sony KP-43HT20 43" Rear Projection...

Not finding what you are looking for?
Sony KP-46WT520 46" Rear Projection HDTV-Ready Television Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Projection Televisions Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

Ap12
Ap12

Level 2 Expert

103 Answers

Jason Harris
Jason Harris

Level 2 Expert

256 Answers

Are you a Sony Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...