Question about Denon AVR-2106 Receiver

1 Answer

Denon AVR 2106 amp failure

2 year old amp. went through some sort of a melt down yesterday, where the speakers started clicking very loud, and I do mean loud. My son thought a plane was heading towards the house. Now we don't have any sound at all. help.

Posted by on

  • dynamike Mar 15, 2009

    Denon AVR-2106 no audio

    I have an AVR-2106... I think you are not supposed to be selling here... pls provide a link to your pricing... I am considering selling...
    I have a similar problem with 3 years old AVR... Upon turning unit off one day, there was amoderate pop sound from all 5 speakers and power light flashed red butdid not shut off. I shut off. Now when I turn on again, there will beseveral seconds of flashing green, then a very slight power relayclick-on sound, but no sound any more. To provide 'more details'requires opening the box. SOmeone mentioned a thermal fuse, can I pull itand exchange it? Thanks... Mike

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 27 Answers

Does it still power up for a little bit or so with no sound what so ever?....I there is no dents in it or metal pushed in causing cracked connector boards....I can take it off you hands for a couple parts I need ...because your transformer and 2 resisters are shot and it will cost almost as much as the unit cost's.

I do have a brand new never opend $649.99 Denon AVR-788 for $365.00.
And 2 used AVR units Denon and Onkyo.....ALL HDMI

call 630 742 6587

Posted on Oct 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Denon AVR-587. It has worked fine for 2-3 years, but ever since I tried to connect it to a different set of speakers, it cuts out after a few minutes and I hear this loud clicking sound coming...


There is a short either on the speaker wires to the speakers or the speakers are defective (some sort of a short or too low of resistance). Lastly, check to see if a stray strand of wire is not touch the left and right terminals. Any short in the network (wire, lack of insulation, staple, screw, etc. ) will cause the system to clip.

Nov 10, 2010 | Denon AVR-587

1 Answer

Denon AVR-2106 - Zone 2 shuts down system


Check your speaker wires on zone 2 and look inthe manual for speaker configurations with zone 2. you may have a speaker conflict. If you still have an issue, post a comment with your speaker setup and I'll help some more. Hope this helps

Jun 28, 2009 | Denon AVR-2106 Receiver

1 Answer

Denon avr-2106 getting hot shutting down


Normally when this happens it is because the impedence load is too small. This unit requires 8 Ohm speakers. If you connect 4 Ohm speakers, it will work, but work harder and generate excessive heat. If the heat is too much, the unit will enter protect mode and shut down. Once it cools off, it will work again. In your case, if the speakers are the correct impedence, check for crossed wires. If that is the problem, running the unit at higher volume levels should cause it to shutdown sooner.

Keep us posted,
Dan

Mar 10, 2009 | Denon AVR-2106 Receiver

1 Answer

Problem getting the best surround sound when watching a dvd


THE BEST SOUND IS WHAT SOUNDS BEST TO YOU, HOWEVER DO THIS:
1, USING THE SETUP MIC CONFIGURE YOUR DENON, PAGE 8 OF THE MANUAL. NEXT
2. RAISE THE REAR SPKR LEVELS, PAGE 46,47. NEXT
3. WHEN LISTENING TO AUDIO CD OR RADIO TRY THE 5 CH STEREO DSP MODE.
4. WHEN WATCHING A DVD USE DSP DOLBY PROLOGIC OR TRY 5CH STEREO IF THE MOVIE IS MOSTLY TALKING.
5, TRY 5CH STEREO WHEN WATCHING PROGRAMS WITH MOSTLY TALKING

Mar 01, 2009 | Denon AVR-2106 Receiver

1 Answer

Denon avr 3000 speaker B is off ,is theres a code to turn it on


I have a Denon AVR-3000 and want to turn on the B Speakers. I have hooked up my subwoofer to the B connections on the Denon since there is not a subwoofer connection. How do I turn the B speakers on without a remote

Jan 27, 2009 | Denon AVR-2106 Receiver

2 Answers

Denon avr-2106 problem!!!


You're drawing too much power from it. Sounds like maybe your sub is hooked up wrong, double check that.

Mar 06, 2008 | Denon AVR-2106 Receiver

1 Answer

Denon 2106


Try making sure the plugs are snug. Always helps me!!

Dec 08, 2007 | Denon AVR-2106 Receiver

1 Answer

HAVE TO UP VOLUME ON DENON 2106 TO HEAR ALL AUDIO IN NIGHT MODE


There should be a volume adjust on the center channel. This is done by the remote exclusively. You may also wish to compress the sound using the dynamic range compression button or so labeled.

Aug 31, 2007 | Denon AVR-2106 Receiver

1 Answer

Denon AVR-2106 troubles


If the surround back is turned on,on the receiver,then the 7CH stereo will activate the 2 rear,but if it's off on the receiver the 5CH on the remote will do the same. I don't know much about the unit changing from 7CH to game,rock Arena etc.that i know will happen if u press the DSP simulation found @ the 3rd. top right button on the remote.

Jan 16, 2007 | Denon AVR-2106 Receiver

Not finding what you are looking for?
Denon AVR-2106 Receiver Logo

351 people viewed this question

Ask a Question

Usually answered in minutes!

Top Denon Audio & Video Receivers Experts

 Elex
Elex

Level 2 Expert

49 Answers

jonpoint

Level 1 Expert

4 Answers

Tech Leprechaun
Tech Leprechaun

Level 2 Expert

61 Answers

Are you a Denon Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...