Question about Carrier Heating & Cooling

1 Answer

Need scedmatic for a tripak system, for a 2005 T2000 Kenworth.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Prodigy:

    An expert who has answered 500 questions.

  • Expert
  • 540 Answers

Checkout the co. website!

Posted on Aug 30, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the fuse position for the dash lights on a 2007 Kenworth t2000 ?


Might be a hard one to locate. i once was a kenworth tech. If all the other lights like in the heater and tach and switches work i would belive the fuse is fine. Pull the dash out and pull the bulb and socket form the speedo. Id be willing to bet the bulb is blown. If all the dash lights are out, just probe the tops of the fuses there is access for testing to find the blown one. Remember the fuses should have power on both sides. If the fuse has no power on either side that is a circuit that is only powered when required. Dash should be powered all the time.

Oct 05, 2017 | Cars & Trucks

1 Answer

1998 t2000 kenworth truck has no running lights or dash lights how to fix them


Fuse ?? this happens sometimes when the trailer has short some place in it , later models use a separation relay to power trailer lghts so that a short would only take out trailer lghts but in 98 they didn't a good shop mech could retrofit one in so that cant happen

Jul 28, 2016 | Cars & Trucks

1 Answer

Where is the motor Heater resistor on a Kenworth t2000 2004


the resistor is normally found by the heater motor in the same cover box, follow wires from motor to resistor should be close.

Jan 22, 2016 | Cars & Trucks

1 Answer

I need a wiring diagram for 2004 Kenworth T2000 with a Cummins ICX engine.


KENWORTH WIRE DIAGRAM FULL - YouTube

? 5:38
www.youtube.com/watch?v=IwFAUHcCTN4
Aug 31, 2014 - Uploaded by Mack Diesel
KENWORTH WIRE DIAGRAM FULL REPORTS THE EMAIL softdieseltruck@hotmail.com softdieseltruck ...

Sep 10, 2015 | Retail Supplies

1 Answer

Kenworth t2000 1998


Should be under the dash drivers side.

Aug 31, 2014 | Cars & Trucks

1 Answer

Need to remove ac clutch on t 2000 kenworth


There are a few different styles for the T2000

One common one you remove the nut in the center and install a 1/2" bolt and tighten it down, this will pop the clutch off the shaft, then just remove the magnet.

the others require a puller

Sep 23, 2009 | Denso Nippondenso RS232

1 Answer

KENWORTH T2000, WIPERS not spraying windshield wiper fluid


one of two problems i make sure the pump is working or the ends on the sprayers are pluged up if so take off and run a small pin in the hole to clean them

Jan 27, 2009 | Jada Option D Kenworth T2000 Truck Trailer

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Carrier Heating & Cooling Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Bill Long

Level 3 Expert

588 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Carrier Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...