Question about Lands Phones

1 Answer

Connected new phones, charged overnight. Out of range signal.No dial tone. Cannot receive incoming calls or make outgoing.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Reported fault to the carrier.

Posted on Aug 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No dial tone cant make calls


No dial tone and inability to receive ring signals are symptoms of connection problems. The installation instructions should indicate how your telephone system should be connected to the network.

Dec 30, 2013 | Lands Phones

4 Answers

I have a GE Cordless 5.8 gigahertz handset and digital answerer. I can see the red light flashing during an incoming call, but hear no dial tone and no ringing. I just replaced the battery. The handset...


Hi,

Did you pay the Bill ?

this seems as if it,s incoming calls only. Check the line with an alternative Phone. This will verify the lines good. And eliminate that One.
Also check if theres A Tone/Pulse setting.
This can also have adverse effects.
If this is on an adaptor fitting with internet access, try removing the adaptor, and plugging the phone direct into the Socket.
Or try the phone on a seperate or diferent Socket.

Hope This helps.

Mike @ compurepair.

Mar 05, 2008 | Lands Phones

1 Answer

I am setting up my Innovage Deluxe Corded Handheld Mini Flip Phone for use with my MagicJack while traveling. 1. I can receive incoming calls fine, just pressing the green phone button to connect and...


First i would say both units are still in good condition as you can still receive calls from them comfortably without any hassles. If you cannot dial out it is probably as a result of the area code or the dial code not being set correctly. The area code helps to determine which location the home phone is situated to enable the calls to be routed through the proper channels to enable connectivity. The dial out code basically does the same as the area code. Both of them are just like address systems to determine where and how the calls are routed. Try setting both codes and see if the calls still dont go.
Hope this solution has been helpful?

May 01, 2011 | Innovage 1502084 Corded Phone

1 Answer

No dial tone phone jack tested ok phone rings incoming call when you pic up nobody. changed battery still no dial tone or conection on incoming call


This is caused by a failed wireless signal transmitter in the base station or a failed wireless receiver in the handset, these phones are not repaired unless they are under warranty, so all you can do is replace it, this is the #1 PROBLEM WITH ALL CORDLESS PHONES.

Mar 22, 2011 | Clarity C410 Cordless Phone

1 Answer

Phone won't transfer to next free line when a second call comes


If you are not getting a dial tone then something is holding the line off hook. Disconnect any other device you have on your lines and check to see if you get your dial tone back. If you still have no dial tone unplug each phone and check again. You may have to disconnect everything for a minute or two so the phone company will reset its equipment. Plug in your phones one at a time and check your dial tone every time you add something new.

If you add something and you loose your dial tone immediately you may have a crossed connection in the wall socket, any splitters or in the phone plug. Check to make sure all of the wires in those sockets are straight before you plug in your phone wire.

If you add your CC machine and everything is good but it fails after you run a transaction you will have to contact the supplier of your CC machine. It is not hanging up the line.

Mar 22, 2010 | Panasonic KX-T7730 Corded Phone

1 Answer

No dial tone no incoming calls or outgoing calls


Have You Tried Replacing The Cable Connecting the Base To the Wall Jack? If Not Do That...
If that doesnt work there should be a channel button on the handset try that...If that doesnt work i would say the handset itself is bad.

Apr 03, 2009 | Uniden Cordless Phone EXAI985

Not finding what you are looking for?
Lands Phones Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lands Phones Experts

kakima

Level 3 Expert

98829 Answers

Cindy Wells

Level 3 Expert

4807 Answers

yadayada
yadayada

Level 3 Expert

63990 Answers

Are you a Lands Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...