Question about Bosch Washing Machines

1 Answer

Bosch exxcel 1100 Washing machine. Problem: water flows rapidly from soap drawer on rinse cycle, checked for blockages and none found

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I'll tell you how I fixed it, seen as you asked... it will cost you $15 though!

Posted on Aug 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bosch washing machine - electronic timer goes down to 1 minute remaining and stays there. Washing liquid has been drained from drawer, however, fabric softener is still there. We have resorted to stopping...


Check if drain filter is clear and drain pump is working properly. Also remove soap conditioner tray and check if you have black residue inside the soap/conditioner dispenser. Sometimes this can prevent water from entering the conditioner tray.

Oct 24, 2013 | Bosch Washing Machines

1 Answer

Bosch Exxcel 1400 washing machine problem


Bosch Exxcel 1400 washing machine This video will show you how to find the fault on a Washing Machine that Won't Drain or empty the water away on Bosch
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.
And don't forget to like us on facebook

Oct 20, 2012 | Bosch Washing Machines

1 Answer

Siemens E14-16 Washing machine is not taking the softener when rinsing and posibly not rinsing completely. the dispenser drawer is clean and flows correctly when filled with water. I have checked the...


Same problem with same Siemens E14-16
Cleaned soap drawer inside out (no more black gunge) but still full of conditioner after full cycle and rinse despite 2 internal valves completely cleared and connected
What could be wrong ?

Feb 13, 2012 | Siemens Washing Machines

1 Answer

The washing machine is taking longer time


You can check that pump filter which is behind the base plinth, also check that the water entering the machine is at a reasonable pressure. If the machine is taking a longer time to wash and both inlet and the outlet of water is ok, it is more than likely a wash side heater fault. Basically, you set, for example. a 40 degree cycle, the heater does not operate and the water never reaches the required temp, the machine ventually times out on the heat phase and then moves on to the rinses or aborts to the end of the cycle.

Nov 26, 2011 | Bosch Washing Machines

1 Answer

How to clean after removal of the dispenser draw, and clean the underneath, and the hole were the liguid is pulled through, as this is clogging up with black water soap sludge. Bosch EXXCELL 1200


I usually hold the whole drawer under the tap and rinse it out thoroughly. If its the middle section (fabric softener) causing a problem just pull up the little flap and make sure the little pipe underneath is clear - it works by syphonic action and the syphon won't start if it is clogged with gunk.

Sep 16, 2010 | Bosch Exxcel WFO 2465 Front Load Washer

1 Answer

Bosch logixx 1400 express washing machine spin is not working . ALSO THE WATER IS NOT BEING DRAINED OUT IN THE NORMAL CYCLE


The 03 error code is the drain. Disconnect the drain hoses and check for blockages. If no blockage "time" the drain interval. If it's more than 6 minutes it's the pump. Also make sure you're using the correct type of soap so the ball check valve on the bottom of the outer drum isn't getting fouled with excessive suds. Also disconnect the drain hose from your house plumbing and let it free flow on it's own. This will tell you if the block is in your plumbing, and not in the machine. Assuming that your filter is clean.

Pl rate me ‘very helpful’ for the free help!

Apr 10, 2010 | Bosch Exxcel WFX 145S Front Load Washer

1 Answer

Water leaking from soap drawer all over the floor during rinse cycle (I think)


probably find a blockage at back of drawer, check the small pipe in the drawer, and unblock this should solve problem

Dec 29, 2009 | Hotpoint Ultima WF860 Front Load Washer

1 Answer

Bosch wfr2460


The 03 error code is the drain. Disconnect the drain hoses and check for blockages. If no blockage "time" the drain interval. If it's more than 6 minutes it's the pump. Also make sure you're using the correct type of soap so the ball check valve on the bottom of the outer drum isn't getting fouled with excessive suds. Also disconnect the drain hose from your house plumbing and let it free flow on it's own. This will tell you if the block is in your plumbing, and not in the machine. Assuming that your filter is clean.

Pl rate me ‘very helpful’ for the free help!

Dec 01, 2009 | Bosch Axxis+ WFR 2460 Front Load Washer

2 Answers

WFR 2460 Front loader


We went through the whole "clean the soap dispenser" deal and results were the same. Exploratory surgery revealed that the Prewash hose (for lack of better term), which connects from the top of the drum housing to the right side of the dispenser drawer (facing the machine)was completely clogged with gunk. Especially strange since we don't prewash hardly anything, ever. The hose that connects the bottom of the detergent dispenser with the side of the drum housing did have a lot of buildup, but I do not believe it was the cause because this was only happening on the rinse cycle. I also found the flow meter was frozen up.
c9cc7cfa-6e34-4571-b319-432b94ce532b.jpg

Jun 27, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

BOSCH WFF 200L


heater element may have gone, when you manually advance the settings you are skipping the heat cycle.

Jun 02, 2007 | Bosch Exxcel WFO 2465 Front Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Tim Whalen

Level 3 Expert

3056 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...