None of my usb ports will work

Your USB ports be must not be updated with the latest drivers for your mouse.Your mouse must not be plug and play model.Install its drivers or reinstall and update your USB drivers.

Your usb device adapter is not working properly just goto device manager disable usb and then enable again.

Did this suddenly start to occur? Were they working before? If so, it is very simple - shut down computer, remove the battery and unplug any power source, wait a couple of minutes and reassemble and power up. Wala! I read all kinds of complicated instructions, started with the simple, and problem solved.

when you plug in something go to computer then double click on the object thats in there and select the brand it is.... EXAMPLE: if you have a zune it might reconize it as an ipod

Which USB ports are you using? I just had this issue on a customer's computer and it turns out that a 5 port USB 2.0 hub they had installed in the pc wasn't functioning properly and so I would get a code 10 on their iPod nano. I plugged it into the onboard USB 1.0 ports and it installed correctly and synched. I would suggest trying other USB ports. If that doesn't work then go to Programs and Features in Control Panel and uninstall all apple products and then reboot and reinstall iTunes.

when you plug it in does anything come up? If not then go ahead and try different usb ports and see if its read by any of them. If none of your USB ports read the magic jack and you know the USB ports work cause you can hook other devices to them then that means the magic jack is bad and would need to be replaced.

If none of your usb ports are reading any devices then that means the motherboard is bad at that point.

Hi..

Did you try the other port of your motherboard. Do not use the front USB socket of your computer, you need to plug i directly to your motherboard ports. If the same things happen. you need troubleshooting.

Try uninstall and reinstall of usb drivers

Remove and reinstall all USB controllers
To remove and reinstall all USB controllers, follow these steps:
Click Start, click Run, type sysdm.cpl in the Open box, and then click OK.
Click the Hardware tab.
Click the Device Manager button.
Expand Universal Serial Bus controllers.
Right-click every device under the Universal Serial Bus controllers node, and then click Uninstall to remove them one at a time.
Restart the computer, and then reinstall the USB controllers.
Plug in the removable USB storage device, and then test to make sure that the issue is resolved.

Good luck!

ICmanServer

its better that u dont use other 2 usb an use just 2 that works.but try this.
go to bios and load default value and save and restart .

I have a solutions that might work, please for the love of god, next time give it as much detail as possible. Navigate to Start>run type:MSCONFIG. Enable everything unless you are absolutely sure you don't need it.
Right click on My Computer, click on properties. Go to the hardware tab at the top, click on device manager to see if there is a conflict.
Try a different port.
Try the hub on a different computer.
If your hub has a power input, now would be the best time to plug it in.
Plug directly into computer.
Make sure the device is plugged in securely, same goes for the devices plugged into it.
If that port is for power only and you plugged it in thinking it would work for data, please don't ask.
Any error messages?
If your computer can boot off a flash drive, Go to bios, test the port and the hub.

Try reinstalling the drivers for the USB by going to device manager.Just uninstall the usb hub drivers and restart the system.Once you restart it, it will reinstall the drivers on its own.Inacse this does not work you would have to get the ports replaced by getting the motherboard replaced