Question about Pyramid MV7SC 7.2 in. Car Monitor

1 Answer

Power to tv

I can not get power to my pyramid tv

Posted by on

  • jdp92130 Nov 17, 2008

    I have a Pyramid MV7SC also, and dont want to tap the power wires into my dash, in case i sell the car or something. Is there a solution around that?

    THANKS!

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 232 Answers

Check the fuse inside the inline filter box located on the power input wires

Posted on Aug 29, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Samsung LED has a flashing blinking light on the front. When I power on, it does not go into standby mode. It just turns solid red for a few seconds and then starts blinking. No image on screen. Is it...


I'm guessing you meant to say 'power off''. Otherwise it sounds like you have reasonably guessed there may be an electronic malfunction -- but with this, as with any device with a 'chip', I'd suggest first literally 'pulling the plug,' or if it's surge protected powering that down. Give it 30 seconds or so, then power back up. Best of luck!

Feb 25, 2015 | Samsung UN32D4000 UN32D4000NDXZA 32 inches...

1 Answer

At power up, tv scrolls uncontrolably through channels, power light flickers


1. Take remote control far away from tv - 3rd or fourth room. Then switch on tv. If uncontrollable scrolling stops , then cause may be remote button (Ch+ or Ch-) has got dirt inside and its shorting.

2. If taking remote far away doesn't stop scrolling then (Ch+ or Ch-) button on front pannel has shorted. Take a cutter plier and care fully remove button from its circuit board. ( If you know desoldering, it is far better than cutting). If scrolling stops then you can operate channel change with remote.

Jan 27, 2014 | Samsung LN46C600F3FXZA 46in Lcd Tv 1080p...

1 Answer

I have just purchase two PL91HRGR headrest screens. I just installed them in my car, and for some reason one of them is keep displaying horizontal "waves" on it with or without a video source. I...


first of all did you buy a video amp . when you install multi screens you need it to get a good signal .
what is the car you installed the tv in ......

sometimes you can get your alternator interfering with your video some people install a filter on the power side of the alternator to help the signal with the audio and video in the car. can try putting a filter also on the power source to the tv 20 or 30 amp inline filter migt solve you problem. where did you ground your screens did you use the same grounding spots or did you ground them at 2 different places.... cause you can have a noise ground or creat a ground loop by not grounding them all together .


here are some pics of inline power filters ans80 by pac and ns50 or the ones to use . try some of these solutions and see what happens and get back to me
carudioquestion@gmail.com

Pnoise-sup-comp.gif

Oct 29, 2010 | Pyle Single DIN Motorized 7 TFT Monitor...

1 Answer

I have two pyramid MV7SC 7.2 in. car monitors. I need information on how to purchase two cable wire that contains the ground, video out,video in, audio in,and volt. (known as the connection wire)


go to say Radio Shack and purchace some Multi cored, (4 -6 core) Co-axial cable, this means you have 4 - 6 "Conductors" and use the shield for all the earths & negative power,. This will give you what you need. At a pinch, you could always get a single core, audio coax, and run 4 of them and tape, or zippy tie, into a bundle.

Feb 23, 2010 | Pyramid MV7SC 7.2 in. Car Monitor

1 Answer

Bmw e39 tv sometimes sound


Hi, I am having the same problems with my 2001 530d sport can you tell me if you solved the problem?

Cheers,

Ron

Oct 07, 2009 | XO Vision GX733 7.3 in. Car Monitor

2 Answers

Phoenix digital pd234


First of all did the set get wet? If so, It needs the boards washed Immediately! Spray boards with windex soak em up. Need to remove all salt deposits and minerals or the boards traces will rot.Then rinse with distilled water let dry Then you could save this set. check this site They rebuild assorted stuff cheap. www.irionstvshop.com

Feb 23, 2008 | Phoenix Digital PD-VIVID 7 in. Car Monitor

1 Answer

Unable To Find Info On Car Sunvisor LCD TV Monitor


i work in a car dvd factory. i can help you.
Remove the origin sunvisor,and install the Sunvisor DVD, There have ACC / Grounded cable/ TV cable in the steel pipe. and the ACC connect 12v. There have a Power /AV input cable in accessories. so,connect this cable to the unit, then connet the power.......
if you want user's manual,contact me.sunwinsales@hotmail.com

Feb 18, 2008 | Sony XVMH6 5.6 in. Car Monitor

Not finding what you are looking for?
Pyramid MV7SC 7.2 in. Car Monitor Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pyramid Car Audio & Video Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

Alan Timperley
Alan Timperley

Level 2 Expert

91 Answers

we_sims2

Level 1 Expert

2 Answers

Are you a Pyramid Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...