Question about Frigidaire Dryers

1 Answer

Dryer won't stay lit

Our dryer is a GLGR642AS3, it will lite when first turned on however it shuts off after about 5 - 10 minutes and will not relite. The vent is clear, any suggestions?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 639 Answers

Dear friend,
ngfam at you service! happy to assist!

It sounds like a gas jet problem, or gas controller problem!
Please call factory service!

If the appliance is 10 years or older its not worth investing money to ix it! The new ones are mush more efficient and clean better!

Either way this is a service problem to remedy!
Below I gave you a nation wide service thats very good!

We sell appliances for 65 years and I recommend this nation wide Factory repair service!

Call A&E Factory Service /They service nation wide
And are available 24/7 for making appointments!

If the appliance is 10 years old or more,it may make sense not to invest any money to fix it!

Happy to assist you,
PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OFF!

Posted on Aug 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The igniter heats and the flame lights, but it shuts off after just a minute or two. It won't go back on until the dryer has cooled down completely. Could it be the high-limit thermostat? With the...


Hello,

What your describing sounds pretty much like the sympthons of weak coils that open the gas valve. It is a fairly common thing that happens with gas dryers so i have written a tip that explains in detail what happens when gas valve coils are weak.
http://www1.fixya.com/support/r10174506-gas_dryer_starts_off_hot_but_after_while


I hope i have helped you to fix your dryer,
GENE

Oct 09, 2011 | Maytag Neptune MDG5500AW Gas Dryer

1 Answer

My dryer ran fine with my last load of only 3 towels. I haven't had any problems with my dryer before. I went to "wrinkle release" my towels and nothing happened. No lights, no 18min. showed...


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Aug 03, 2011 | Maytag Neptune MDE5500AY Electric Dryer

1 Answer

Dryer lites but wont stay lit


Hi, If you have a gas dryer2_bing.gif.
The most common problem with a gas and no heat is the ignitor going bad...

Here is a tip that I wrote about that problem...

Gas Dryer2_bing.gif not Working Gas Dryer2_bing.gif Not Heating
http://www.fixya.com/support/r4398592-gas_dryer_not_working_gas_dryer_not

If your dryer2_bing.gif is electric2_bing.gif..
There could be a number of different problems...
Check out this tip that I wrote about this problem...

Dryer2_bing.gif Troubleshooting2_bing.gif Electric2_bing.gif Dryer2_bing.gif won t Heat
http://www.fixya.com/support/r3866345-dryer_troubleshooting_electric_dryer_won

heatman101

Jun 06, 2010 | Crosley CDG6000 Gas Dryer

1 Answer

Roper Model RGS7648EQ3 (gas) that wont stay lit.


if the ignitor is liting for the first 15 to 30 minutes and then it will not lite again you have bad gas coils,when they are failing they will work until they get hot then they shut down,the coils are located on top of the gas valve,take out the two phillips screws,remove the cover,change out one coil at a time,pull off the wire connector and install the new coils

Mar 19, 2010 | Dryers

1 Answer

Burners won`t stay lit.........


There are several possible causes for this. Bad flame sensor, bad thermostat switch, blocked air vent, or bad gas coils.

This website
http://www.acmehowto.com/howto/appliance/dryer/diaggdryer.php

Has very good troubleshooting and repair information for all of the possibilities

Feb 02, 2010 | Maytag Neptune MCG8000AW Gas Dryer

1 Answer

Alantis Gas Dryer MDG7600AWW not staying hot or lit


All you need to do is replace those pesky intermittant coils
aab79a0.jpgI wote a short essay on this problem. To keep from being redundant I have it HERE

Mar 02, 2009 | Maytag Dryers

1 Answer

Dryer won/t work


Hello chuhunghuang
Welcome

You said, your control lock light is lit. dryer will not work
Let me know how it goes!

Try ,
Pressing STOP/CANCEL to clear the display.
If this does not work.
pull the plug for 5 minutes or if you can't reach the plug you can turn the power off form th breaker for 5 minutes.
This should reset the system.

Let me know how it goes!
Bless You huuum
Please leave a rating before you leave the site!

Oct 12, 2008 | Whirlpool GEW9250P Electric Dryer

1 Answer

Whrilpool gas dryer


DISCONNECT THE EXHAUST FROM THE BACK OF THE DRYER AND TRY DRYING ONE LOAD OF LAUNDRY. IF THE DRYER WORKS O.K. WITH THE EXHAUST DISCONNECTED, YOU HAVE A RESTRICTION IN THE EXHAUST DUCT SOMEWHERE.

Apr 22, 2008 | Dryers

1 Answer

Kenmore gas dryer igniting problem


check the flame sensor. it could be the problem since it would ignite first then if the flame sensor is mal functioning, it would indicate a "no flame" signal that would cut off the fuel solenoid. then it would shut it off.

Feb 13, 2008 | Kenmore 63942 Dryer

Not finding what you are looking for?
Dryers Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Are you a Frigidaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...