Question about Apple iPod MA446LL/A MP3 Player
I have problem with my video iPod. It just stoped to recharge via usb. It is completely ran out of energy and I lost my wall recharger. So the only way that left was to recharge it via usb port. But it does not work any more. There is no feedback from iPod at all when I plug it into usb. No regarging, no message on the display it just stays black. Can you help me with this?
I have seen this many times. Your battery is most likely depleted to the point that it is incapable of sending a signal to the computer. You will more than likely need to have you battery replaced. You can jump start your iPod with a wall charger, but you lost yours. A simple charger can be bought off of eBay for less than ten dollars. If you get a wall charger and nothing happens, your iPod is dead but it sounds like a battery issue.
Posted on Aug 29, 2008
Tips for a great answer:
Reset your GoGear with something sharp like the tip of a pen or the end of a paper clip,
if you're device isn't working properly or there's a frozen display.
Insert the sharp object into the "Reset" hole (located at the bottom of the player), and hold it there until the device turns off.
If resetting the device does nothing to restore the display, access the "Philips Device Manager" through your computer to recover the GoGear.
Click "Start" on your computer, then "Programs," "Philips Digital Audio Player," "Aria Device Manager," and then "Philips Device Manager."
This will launch the "Philips Device Manager." Make sure the GoGear is turned off completely. Connect your GoGear to your computer while holding down the "Volume Up" button.
Continue to hold the "Volume Up" button on your GoGear, until the "Philips Device Manager" recognizes the device and enters recovery mode.
Click the "Repair" button when it appears on your computer, then folow the steps to fully recover the GoGear.
Properly disconnect your GoGear from your computer and restart the device.
Recharge your device if your GoGear dies suddenly while playing.
Connect the GoGear to your computer via the supplied USB cord.
Plug one end of the USB cord into a functional, open USB port on your computer. Plug the free, smaller end of the USB cord firmly into the small USB jack on your GoGear and turn your computer on.
This will begin the charging process of your GoGear.
If recharging doesn't work, the battery may need to be replaced.
Check that your GoGear isn't in standby mode. Hold the "Power" button for two seconds to turn it back on.
hope this helps
Oct 07, 2012 | Philips GoGear ViBE SA1VBE08K MP3 Player
on Aug 09, 2011 | Apple iPod touch
Sep 30, 2012 | Ematic Esport Clip 4gb Mp3 Video Player,...
Aug 21, 2010 | Apple iPod classic MP3 Player
Dec 19, 2009 | MP3 & Digital Media Players
Nov 24, 2009 | Apple iPod MA446LL/A MP3 Player
Oct 22, 2007 | MP3 & Digital Media Players
55 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: