Question about Comet BXD2527 Pressure Washer Pump

1 Answer

Protective Gear Question

Do I need protective gear?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

Always wear eye protection. Pressure washers often cause grit & muck to fly about at high speeds. Keep the area you are cleaning clear or people and animals.

Posted on Aug 27, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The car would not go into gear

if this is a new clutch kit that has been put in then it is more than likely that the clutch plate has been install incorrectly and the hub is hitting on the flywheel bolts
If it not a new kit then the clutch system is at fault hydraulic or cable

Jul 05, 2015 | Karcher KIT, ADAPTOR PLATE

2 Answers

I have a 16hp pressure washer Briggs how do I adjust the pressure?

They are set at the factory if its dropped in pressure it couldhave popped an O . Ring. Check out.

Jul 26, 2014 | Cam Spray 4000BT 16HP Briggs 4000psi 4GPM...

1 Answer

What oil do you use in gear box of gx 340

If it's a pump gear box then use 80-90 gear oil

May 04, 2014 | Honda Garden

1 Answer

Honda power washer parts diagram

what gear oil ??? it should be a non detergent motor oil but this all depends on the brand of pump that you forgot to mention

Oct 19, 2013 | Honda Pressure Washer PSI 3000

1 Answer

Broke the plastic gear inside

You did not say engine make or modell number (i.e. Honda GC160). A great place for parts is Presure Washer Store and Small Engone repa

Oct 23, 2012 | Garden

1 Answer

I have a Coleman 2200 6hp green tochemsa engine pressure washer and wanted to know what type of oil is used in the water pump? PLEASE LET ME KNOW.

The recommended oil is determined by the pump manufacturer (usually different from the engine), but most of the "consumer grade" pressure washers say you never need to change the pump oil. Maybe they figure something else will break before it needs new pump oil?

The little jugs of pump oil at home improvement stores are usually SAE 30W (non-detergent) crankcase oil. 75W90 gear oil seems like a better choice; I personally use synthetic marine lower unit gear lube in my pressure washer pump. It's a little more expensive, but I think the formulation gives better moisture resistance. Besides, the pump takes a fairly small amount, and I don't change it very often at all.

Bottom line- you almost certainly want non-detergent oil, around 30W crankcase/80W gear (since they use different scales, these are just about the same viscosity). Synthetics seem to be higher quality, and using marine grade lube gives me peace of mind.

The pump oil matrix here is illustrative- note the many substitutions allowed. The specific oil you choose probably doesn't make much difference, especially compared to never changing it.

Jul 16, 2011 | Coleman Garden

1 Answer

I cannot get my honda 2500psi pressure washer to start at all i have changed spark plug and do have spark it has good gas in it and plenty of oil but will not start?

Three things needed for engine to run. Fresh fuel, good spark and good compression. I am assuming that water supply is disconnected for now and that you feel good resistance when you pull the rope indicating that there is compession. For now remove/unplug the low oil alert wire (if your model has one). Use carburator cleaner as fuel for now by spraying fuel directly into carb with air filter removed and choke off (do not flood just spray a little then little more if needed, the engine will only begin to run then stop unless you contine to spray fuel). If the engine does not respond most likely timing belt or plastic cam is cause. GCV series honda engines use timing belt with plastic cam gear. Gx series use metal gear. If the engine responds clean carb. Good luck

Jul 08, 2011 | Honda Garden

1 Answer

There are 2 different places to add oil to my 3500 Honda engine pressure washer (cold). Do I use SAE 30 for the motor oil and gear oil for the other oil?

you can use sae 30 in the motor and hydraulic oil or gear oil in the pump.
just note that there may be two oil filler holes on the motor.

Nov 25, 2010 | Honda Landa PG 3500 PSI Pressure Washer

1 Answer

B & S 675 series engine timing question

The gear on the crankshaft is 'keyed' and has a dimple on one of the teeth. That dimple aligns with the dimple made into one of the teeth on the camshaft.

Nov 15, 2009 | Briggs & Stratton Garden

Not finding what you are looking for?
Comet BXD2527 Pressure Washer Pump Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Comet Garden Experts

John Trevino

Level 3 Expert

1383 Answers

Joseph Hoffmann

Level 3 Expert

1696 Answers


Level 3 Expert

2405 Answers

Are you a Comet Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides