Question about RCA D52W20 52" Rear Projection HDTV-Ready Television

1 Answer

Westinghouse plasma tv repair

My tv display was hit and damage during moving is there any cost efective way to repair it, (attached picture)

Posted by on

1 Answer

You will have to take it to a shop to have it repaired

Posted on Aug 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

During a storm, my tv was plugged into an outlet and it was working fine and in a minute, it turned off by itself. Now the tv does not work. There is no sound, no picture. The only thing thats still on is...


It got hit by lightning I believe. I hope you have insurance. It will most likely be in the power supply board. My recommendation is if you have cost replacement insurance is to get a new one. Once a tv get hits by lightning it is hard telling what other damage may be lurking.

Oct 20, 2009 | Hitachi 60DX10B 60" Rear Projection...

2 Answers

Hit by litning


my friend it is the tv tunner that needs to be replace you will have to take your set to a repair shop for repairs.tv needs qualified tech to repair them.you might cause injury to your self.although you want to save money it is best to have a tech deal with your tv,than doing more damage to your tv and to yourself.it will cost you less on the longer run.good luck

Jun 19, 2007 | RCA Scenium HD65W20 65" Rear Projection...

1 Answer

My 62 inch mitsubishi tv was hit by lighting


Try to find a local repair centre & ask if they can give you an estimate on the cost to repair. A lightning strike can cause either minor damage such as just an internal fuse blown or can cause severe damage which will wipe out entire circuit boards which can be a costly repair. In this case it's usually not worth repairing.

Oct 07, 2009 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

Cost to repair an LCD tv screen


In today's electronics devices there isn't much to repair specially if the screen is damage. The cost of the repair might exceed the price of the LCD. A cheaper way to get it fix is to try to find a defective LCD(same model) with intact screen.

Sep 28, 2009 | RCA P52960 52" Rear Projection Television

1 Answer

50HX70 picture


Hello jcside,

its not a costly repair the parts cost about $13.99 each (Convergence Amplifier ICs) Just remember you will need to change both of them. Also you will spend about $10 - $15 on the bias resistors.

Here is some advice I posted sometime ago, it applies in your case:
This denotes a convergence problem as you surmised. Believe it or not it would be cheaper for you to replace the two convergence amplifiers and the biasing resistors. You would not actually be replacing the convergence board since these devices are usually located on the deflection board in most cases. However in answer to your question, the boards are easily removed, depending on your level of patience (lots of cables to move around), I would also advise you to either mark down all of the connection you will remove, or take pictures of the board and its connectors. If you choose to just replace the Amplifiers and the biasing resistors there is a lot of information on this site on how to do so: This will get you started:

1) Unplug the TV and then get a schematic of the TV I use http://www.servicemanuals.net or http://www.manualsparadise.com
2) On the schematic locate the STK392-xxx series IC packs (usually attached to a large heat sink)
3) determine if the STK392s are 110, 120 or 150.
4) if the STK392-xxx's are 110s replace with 110s (forget that upgrade stuff it is a hit or miss game that I don't believe you want to get into), if they are 120s replace with 120s and so on.
5)Now to replace the STKs: remove the module from the TV and unsolder theold STKs along with the bias resistors, and replace them with the newones (be sure to apply heat sink paste to the STKs when attaching themto the heatsink)
6) make sure there are no short circuits form your soldering job.
7) Reinstall the module and then turn on the TV.
8) do manual adjustment and the auto-convergence test and then things should be back to normal.


I hope this helps

Shuttle83

http://www.electron-age-technologies-llc.com

Now if you think you can do this have at it, if not I would suggest that you have it done by a qualified TV technician.

Feb 14, 2009 | Toshiba 50HX70 50" Rear Projection...

1 Answer

Transporting plasma home something hit the screen now the tv is not working. It is a sony 106cm plasma. Can this be fixed and be cost effective or better to buy a new one


If you damaged the plasma display, the job willbe over $1000, depending on the model.

If you damaged a different part, the repair wont be less than $200 in the best case.

I suggest to call the manufacturer and ask the cost for a warranty extension.

A warranty extension costs usually less than one single repair ($200 or less for an average plasma TV), and will cover all repairs for one year.

If you want to call the manufacturer you can use the phone number listed on the owner manual.

Nov 06, 2008 | Projection Televisions

1 Answer

Blue is good but I couldn't adjust the red and the letters have laggig red behind them and the picture hvae red eyes and also red shadows


Right now I am troubleshooting the same problem. If you go into your picture menu on your tv go to manual red convergence and hit right. It should give you 3 sets of cross hairs and your red will be able to move up and down and from left to right. If yours is anything like mine your red will not move from left to right but will have no problem going up and down. If this is the case, chances are that there is a resistor blown on the board attached to your tube that controls the red (far left looking from the back). If you don't feel good about checking resistors and diodes on that board DO NOT start taking things apart. repair costs will only get bigger the more you take apart.

Sep 13, 2008 | Projection Televisions

1 Answer

Toshiba TN55V71 55 in. Rear Projection - Damaged


Hi. If the convergence is out but uniformly then chances are its not electrical problem more likely to be physical see if the 3 small crt tubes are loose & can move about. Or was your stuff insured during the move if so put in a claim.

Sep 23, 2007 | Toshiba TN55V71 55" Rear Projection...

1 Answer

Mitsubishi vs 60719 - Wavy bow in picture


Either a bad solder connection on your convergence module or a bad convergence IC. Repair costs will probably be in the $350-$500 range.

Jan 28, 2007 | Mitsubishi VS-60719 60" Rear Projection...

Not finding what you are looking for?
RCA D52W20 52" Rear Projection HDTV-Ready Television Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Are you a RCA Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...