First check the neck of the bottle and clean it if dirty
secondly if this does not cure the fault then the sensor in the drum assembly is probably dirty. You will ether have to strip off the end of the drum and clean the led and photo sensor or replace the drum unit.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
KM-6030 or FS-6030. if it is the fs open the fron door, remove the waste bottle and replace it with a new one (they come with the toner). if it is a KM or CS 6030 that should be covered under your service plan. if you are running a segment 3 machine without a service contract you need to reevaluate your situation.
facing prnter look on left side. midway of side panal theres a door. push tab on door to the rear of printer a bit and door should open. depress plastic tab on neck of toner coleection bottle and pull out full bottle. replace or empty an dreinstall and cloe door. should reset and restart to ready condition.
Hi, Sound like drum unit is out off position.
Switch off printer.Open left side door, remove waste toner bottle and push drum unit(with grej lever on it) in printer to proper position.If grey lever is not in proper position, drum will be not locked.Place waste toner bottle in position.Switch on printer.
AP = Adding Powder (toner) it's not an error
it's adding toner from the container into the developer unit while displaying AP. when there is enough toner in the container the AP will disappear and copies can be made when there is not enough toner in the container the toner empty light will come on.