Question about Office Equipment & Supplies
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
It could be that there is a loose piece of thread, or some fluff which is obstructing the tension gauge. Try blowing around the theading area (or even run the hoover pipe near it to see if you can **** it out). I cleared mine by folding a piece of non fluffy material and rubbing gently between the tension dial and machine.
Posted on May 22, 2008
there are a couple of things did you buy genuine or reman cartridges and check if they are seated properly.
some remans dont work properly so you have to be sure and always get a money back guarantee from the seller
Posted on Jun 08, 2008
ok it can be a bunch of things,
1) check the cover that you open to change the cartridge is secure, press down on the top part near the latch that releases it and see if the door switch activated, if you hear the main motor activate then your problem is the locking latch.
2) Change cartridge and /or clean the 2 metal square contacts under the drum, move the drum cover and you can see the 2nd one, use methylated sririts or equivalent and a cloth. Your cartridge may be faulty/old or has leaked toner on the contacts.
If neither of these work you will have to have a visit from a technician as a circuit board may be at fault.
Posted on Jun 11, 2008
hi,are you sure no paper jam ok check very very small paper in your machine or clean the sensor.
Posted on May 14, 2009
Tips for a great answer:
Apr 15, 2018 | Bernina Sewing Machines
Dec 06, 2016 | Bernina Sewing Machines
Oct 13, 2016 | Bernina Sewing Machines
Feb 09, 2013 | Sewing Machines
Jan 10, 2013 | Sewing Machines
Apr 20, 2011 | Bernina Virtuosa 150
88 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: