Erreur 00010014 for my epson 9880 - Epson Stylus Pro 9800 InkJet Printer

most likely you're wiper for the capping station is covered in ink. I recommend having the printer cleaned by someone who does maintenance on Epson printers.

Different model, but the internal backup battery is exhausted.

Epson Stylus Pro 7700 Service Manual [Page 129] - ManualsLib

https://www.manualslib.com > ... > Service manual
Note : Ex): When "Maintenance Request 0088" is displayed. ... occurring simultaneously. (Bit-3: battery exhaustion/ Bit-7: the date and time has not been set.).

..

The 00010014 error code means that the Ink System Pressure Sensor reports that it is in low pressure. The error usually is caused by an Ink Cartridge that leaks pressure.

http://www.epson.co.uk/Printers-and-All-In-Ones/Large-Format/Epson-Stylus-Pro-7800/Drivers-Support?target=article&extn=.html&articleId=4286

Here is a support link for error codes---hope this helps.

00010014 - Ink System Pressurization Error (The Pressure Sensor does not indicate pressure) CClick HERE to view full detail on troubleshooting process.
EXPLANATION:

The error codes in the table below relate to a faulty ink cartridge or detection of the cartridge when installed in the printer. These errors only occur when an ink cartridge is changed. Whilst you may be unable to quickly identify which ink cartridge may be at fault, the steps below provide a process of elimination.

hi

see if this helps

http://files.support.epson.com/pdf/pro7880/pro7880ug.pdf

let me know if it does not and i iwll continue to help

SERVICE CALL 00010014
Description
Failure of pressurizing

The problem is with the ink cartridge. remove the ink cartridge then insert it again... if this does not work, replace you ink cartridge. hope this help. Good day!

The same has happened to me I replaced one of the inks and got the error message 0010014. I replaced the ink cartridge with another and it began working again or maybe this link might help you.http://www.epson.co.uk/Printers-and-All-In-Ones/Large-Format/Epson-Stylus-Pro-7800/Drivers-Support?target=article&extn=.html&articleId=4286
Good luck!!

00010014 Pressurization error
Ink supply pressure incorrect
Explanation
The pressure system is determined to be leaking then this message appears and printer is stopped when detection of pressure origin sensor is incorrect at power on initialization or ink supply.
Solution
1. Replace supply pump assembly (including pressure origin sensor solenoid).
2. Check for disconnected air tube.