Question about Nintendo Wii Fit for Wii

2 Answers

Wii fit cant syc thewii fit console and balance board as we have lost the instruction manual. any suggestions

Posted by on

  • Anonymous Feb 21, 2009

    MY FITNESS BOARD WON'T STAY ON/ BLUE LIGHT GOES RIGHT OFF

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I found this on a related post, but it should help:

Hi,
After posting my message here I started to fiddle around with the wii fit again and went slowly step by step through the synchronisation steps. Voila it works! what I had done wrong was that I did not press the red synchronisation button for the wii console when the blue lights (after pressing the sync button) on the wii fir board started to flash. you must do this when they are flashing. Hopefully you are as lucky as me and it will work for you too.

Posted on Dec 31, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have same problem

Posted on Sep 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to connect wii fit board to the wii


Important Note!
Do Not use "One-Time Mode" sync.
Syncing can be completed only if a compatible game disc is running in the console.The Wii Balance Board may need to be synced to each compatible game individually.Some games may require you to go into a specific screen to sync the Wii Balance Board.These sync settings will be saved even after the console is turned off.

1. Insert a Wii Balance Board compatible game disc in the Wii console.
2. Use the Wii Remote to select the Disc Channel from the Wii Menu, then select "Start" to begin the game.3. Open the SD Card slot cover on the front of the Wii console.4. Remove the Battery Cover on the bottom of the Wii Balance Board.
5. Press and release the SYNC button on the Wii Balance Board. The Power LED on the board will start blinking.
6. Press and release the SYNC button on the console while the Power LED on the board is still blinking.
7. The Power LED will stop blinking and light steadily once the synchronization is complete.8. Replace the battery cover and return the board to the normal operating position.

Nov 16, 2011 | Nintendo Wii Fit for Wii

1 Answer

Communications with the wii balance board interrupted


dont push your feet hard or the batteries might come off of the cap isnt put on or the batteries are fully used

Feb 12, 2010 | Nintendo Wii Fit for Wii

1 Answer

We used our wii fit on another wii system. After


Hello,

    Try these steps!

  1. Insert a Wii Balance Board compatible game disc in the Wii console.

  2. Use the Wii Remote to select the Disc Channel from the Wii Menu, then select "Start" to begin the game. Press the A Button to bypass the wrist strap screen.

  3. Open the small SD Card slot cover on the front of the Wii console.
  4. Remove the Battery Cover on the bottom of the Wii Balance Board.
  5. Press and release the SYNC button on the Wii Balance Board. The blue light on the board will start blinking.
  6. Press and release the red SYNC button on the Wii console while the blue light on the board is still blinking.
  7. The blue light will stop blinking and stay on steady once the syncronization is complete.
Fore more detailed information (including pictures) on how to sync the Wii Balance Board, click here.

If you are still unable to sync your Wii Balance Board, please call 1-800-255-3700 so that they may assist you further.

Hope it helped.


Nov 22, 2009 | Nintendo Wii Fit for Wii

2 Answers

Please step off press A - constantly repeated - why???????????




If the Wii Balance Board fails to operate, or operates incorrectly, follow the steps below before seeking
assistance.
A. Check the batteries.
B. Check to be sure there is nothing pressing against the bottom.
C. If you are using it on soft carpet, put the foot extensions on.
1. The Wii Balance Board does not respond.
• Make sure the power is turned on. The blue Power LED should be lit if the Power Button has been
pressed. (The Power Button faces away from the TV.)
• Make sure the board has been placed correctly (see page 6).
• Make sure the batteries have been inserted correctly and are not been depleted.
• Make sure the game you are playing is compatible with the Wii Balance Board.
• Review the synchronization procedure on pages 7-8 and make sure this has been done correctly.
This procedure must be done for each Wii Balance Board compatible game.
• If, after verifying the steps above, the Wii Balance Board does not work, try the following:
1. Turn off the power of the Wii console with the POWER Button on the front of the console.
2. Unplug the power cord from the wall outlet for a few seconds, then plug it back in again.
3. Turn on the power of the Wii console.
4. Repeat the steps in this Operations Manual for setting up the board.
If the Wii Balance Board still does not work, follow the information at the bottom of this page.
2. Control of the Wii Balance Board is inconsistent or seems incorrect.
• Review the Instruction booklet for the game you are playing to make sure you are performing the
correct actions for that game.
• Make sure the board has been placed correctly (see page 6).
• Try using the Wii Balance Board foot extensions if you are using the board on carpet (see page 10).
• Make sure there are no people or other objects between you and the Sensor Bar.
• Avoid interference from other devices. If communication seems to be affected by other devices
(wireless LAN, microwave ovens, cordless devices, computers) move to another location if possible,
or turn off the interfering device.
If the Wii Balance Board still does not work, follow the information below.
If the Wii Balance Board still does not work, an operational check procedure is available
in the Options Menu of the game you are playing. See the Instruction booklet included
with the Game Disc for more information. If your Wii Balance Board does not operate
correctly after all of the above steps, visit support.nintendo.com for assistance and
additional troubleshooting and repair options or call 1-800-255-3700.

Jul 19, 2009 | Nintendo Wii Fit for Wii

2 Answers

My wi power source just quit


Guest: Rechargable batteries are only 1.2 V each. You should get up to 4.8 V.

I highly suggest running your Wii Fit on nothing other than Alkaline batteries. I've had my Wii Fit for over 3 months and still use the original batteries.

If you feel like you need rechargables, that's fine, but I recommend a quality set of regular AA rechargable batteries that comes with a quick charger (IE: 1-hour). Stick to the same brand of batteries and buy enough for each Wii-Mote, Wireless Guitar, Wii Fit Balance Board, etc.

Amy - Keep in mind that your Wii Fit balance board will ONLY turn on when your program (ie: Wii Fit) is loaded and ready to go. Since the balance board takes up one of the four available Wii-Mote channels, make sure all but one Wii-Mote is turned off before starting Wii-Fit.

Apr 29, 2009 | Nintendo Wii Fit for Wii

1 Answer

Balance board not working properly


Regrettably, this seems to be a very common problem. Please contact customer service at www.nintendo.com to see about getting repairs made to your Wii Fit Balance Board.

Mar 26, 2009 | Nintendo CTA Digital WI-BBP Wii Fit...

3 Answers

Canot use Wii fit balance board


Ensure batteries are fresh. Ensure that Wii Fit (or other Balance Board game) is started up completely before pressing the power button.

Jan 04, 2009 | Nintendo Wii Fit for Wii

1 Answer

Unable to sync Balance Board and its knocking the remotes out too


When you are prompted to press the sync buttons you just have to press and release just once the sync button on the console and then on the board. Do not hold the buttons in because you just end up un syncing everything!

Dec 27, 2008 | Nintendo Wii Fit for Wii

1 Answer

Cant sync wii balance board


I know it's been a while since you have posted and have prob already figured it out. But just in case this may help someone else. Try turning off your wii and unplugging from the power source for a few minutes. The plug back in and turn on. At the initial warning screen press and hold the sync button on the wii console for about 4 sec. You will have to resync your wii remotes. Next make sure the disc for the game you are going to use the balance board with is in the system and start the game. Then try to sync the balance board.

Nov 17, 2008 | Nintendo Wii Fit for Wii

Not finding what you are looking for?
Nintendo Wii Fit for Wii Logo

480 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nintendo Video Game Accessories Experts

pwetherhill

Level 2 Expert

44 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Josh Whitehead
Josh Whitehead

Level 3 Expert

1146 Answers

Are you a Nintendo Video Game Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...