How can you change to channel 3 without remote?

Most TVs have a way of changing the channels manually. One of the buttons on the device will change the channels up or down.

Could be on the center TV.

U should have a menu button on your tv.If so try to find the channel setup option if you find this you should b able to manually go through your channels to add & delete the channels you want.If not you will have to go out a buy a universal remote.Make sure that it is compatibl to your tv.They should be a list on the back of the remotes pack stating all the brands that the remote is compatible with.I think you should be able to get one for unde 5 dollars.in the pack it should have an instruction manual.some tvs u can set up very easily & some you might have to keep putting in different codes until it works.Hole this could be some help to you.Good luck.

look u cant chane directly to channel 3,,,there is a solution,,jst do it mannually from the buttons available on the t.v

go to menu and see if you have channel selection on go down thaT way. you should be able to program it in.

Usually if you go into the setup menu, there is an option to allow you to either "scan" for a channel, or "input" a channel. In this case, select "input" and see if the TV will allow you to press the up and down channel buttons and go to a specific channel. If so, when you get to channel 4, press the "add this channel" option (or whatever the menu option says) and you should then be able to go to channel 4 using the buttons on the front without skipping over it.

I had the same prob and found the answer posted elswhere.
This worked for me...

If you go into the main menu under Setup --> Guide Setup --> Set Auto-Tune to "YES".

now the channel will change without the 3 digit requirement.

l. Push the "Menu button"
2. Push the "Menu button" again
3. Scroll to "Setup" and push "OK"
4. Scroll to "Guide setup" and push "OK"
5. Scroll to"No Auto Tune"
6. Click on arrow next to "No Auto Tune". This will change it to "Auto Tune".
7. Now exit, or just punch in any channel number.

You should now be able to go directly to a channel without entering zeros.

The easiest will be to make sure that the cable box is on and sending out a signal to Channel 3 and auto-programming the set. Channel 3 is skipped because the last time it was auto-programmed, there was no signal on that channel.

Dan