Question about HP Photosmart 435 Digital Camera

2 Answers

Not turning on

With batteries fully charged the camera will not turn on when you slide it to turn it on. This happned without any reason.Can you help me camera was dropped and now battery door is loose-when connected to wall charger the green light flashes & the screen says "connected to ac power-beginning to charge battery then the battery symbol appears and the screen goes black. the green light flashes & a red light beside the view window flahes but very dim. but if you hold down the button w/ the camera symbol and press the down arrow at the same time the red light flashes very bright until the button is let go. Once the camera is taken off the ac power cord it does nothing

Posted by on

  • cuteky96 Sep 01, 2008

    i slipped dropped my camera and now the front of its loose and it wont turn on! help me!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I TURN THE CAMERA ON BUT THE IMAGE DISPLAY WILL NOT TURN ON

Posted on May 01, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 876 Answers

The batteries probably need to be replaced. Be sure that any batteries seat properly and tightly. You may have to tape the battery door shut with strong tape to keep the contact tight. This type of damage is expensive to repair compared to the cost of the cameras. You can take it in and have it looked at, but be sure to get an estimate and then you can make an educated decision on whether to repair or replace it.

Best wishes to you and Thank you for using Fix Ya!

Posted on Aug 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nikon troubleshooting


so long as the battery is fully charged it should turn on, you can't take a photo without a sd card but you should be able to turn the camera on and navigate menus.
it sounds like you have a defective unit

Dec 23, 2013 | Digital Cameras

1 Answer

My camera does not turn on with the battery in it. When it does turn on it stays on for less than a minute. I have already replaced the battery twice.


Welcome to FixYa.

Two reasons why the camera automatically switch off.

1. The battery is exhausted
- try to insert fully charged battery or replaced a new fully charged battery.
2. The camera stopped due to malfunction.
- removed/ re-insert battery and switch the camera on.
For more details and troubleshooting steps of your camera, here is the link for your free manual. Just click here

I hope this solution will help.
Feel free to send us your comments and suggestions if this solution is helpful.

Thank you for using FixYa.

Apr 07, 2011 | Digital Cameras

1 Answer

My battery is fully charged but when i turn the camera on it shuts right back off


SOunds like your battery is bad. try discharing it :
  1. Place the battery in your camera until it itself turns off. In this situation, the battery is fully discharged.
  2. Take out your battery and slide it into your battery charger.
  3. Connect your charger with power to fully charge the battery. It is normal for a new battery that battery indicator shows 100% capacity in 10 to 15 minutes. Please keep charging until there is no time left for charging.
  4. Fully charged and fully discharged or "cycled" as much as five times to condition them into performing at full capacity.
Try it and see if it works? If the batteries are not rechargeable then the problem is in the cameras power supply and you need to take it in or replace it.

Jun 13, 2010 | Sanyo VPC-T1060 Digital Camera

1 Answer

It won't turn on it drop from me once and now it won't turn on


In order to clearly determine the fault the model of your KODAK camera is needed However I hope this will help: If your cam use AA batteries: Here are the steps for the no power problem: 1. Make sure you will install a new or fully charged battery/batteries into your camera. Please use lithium batteries Ni-Mh or rechargeable Batteries (2000 M.Amp or higher). 2. Clean the battery contacts. a. Remove the battery/batteries and the memory card from your camera, then wipe the battery contacts with a soft, clean cloth. b. Reinstall the battery/batteries into your camera 3. Turn on your camera without the memory card. If your camera model requires the manufactures batteries: Here are the steps: 1. Make sure you will install a new or fully charged battery/batteries into your camera. 2. Clean the battery contacts. a. Remove the battery/batteries and the memory card from your camera, then wipe the battery contacts with a soft, clean cloth. b. Reinstall the battery/batteries into your camera. Please make sure that you are installing a fresh/ fully charged battery c. Without the memory card, turn your camera on. 3. Please test with the a different battery If you do not have access to another battery Try these steps instead: Please take the battery out of the camera. b. Insert the charger into the unit from the main socket and turn the camera on. If the camera works you will need to replace the battery. If you camera doesn?t switch on you will need to order a No power repair or a new cable. In order to organise your repair or Trade up please Contact KODAK: http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=14563&pq-locale=en_US&_requestid=3490

Jan 03, 2010 | Kodak EasyShare One Digital Camera

1 Answer

I have tried several new batteries,and camera wont turn on.for some reason the batteries and flash button become very warm...


Pls. use lithium batteries Ni-Mh or rechargeable Batteries (2000 M.Amp or higher).

Here are the steps:
1. Make sure you will install a new or fully charged battery/batteries into your camera.
2. Clean the battery contacts.
a. Remove the battery/batteries and the memory card from your camera, then wipe the battery contacts with a soft, clean cloth.
b. Reinstall the battery/batteries into your camera
3. Without the memory card,turn on your camera.

Contact KODAK:
http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=14563&pq-locale=en_US&_requestid=3490

Nov 18, 2009 | Kodak Easyshare C813 Digital Camera

1 Answer

My Kodak af 3x optical aspheric lens camera won't turn on. it was fine yesterday but today it wont turn on. I've charged it and everything but it doesn't do anything. Help!


Here are the steps:

1. Make sure you will install a new or fully charged battery/batteries into your camera.

2. Clean the battery contacts.

a. Remove the battery/batteries and the memory card from your camera, then wipe the battery contacts with a soft, clean cloth.
b. Reinstall the battery/batteries into your camera

3. Without the memory card,turn on your camera.

If issue persists, call 1.800.235.6325 for repair.

Sep 24, 2009 | Digital Cameras

1 Answer

Camera won't turn on, just beeps


first check the battery... charge or replace it... else reset the camera or repair

Sep 05, 2008 | Olympus Camedia D-510 Zoom Digital Camera

1 Answer

Camera will not power on or off and battery is fully charged


The symptoms you describe sound very much like a failing battery. How old is your battery? Rechargeable batteries are only meant to last for a couple years, regardless of use.

Apr 03, 2008 | Canon PowerShot SD400 / IXUS 50 Digital...

2 Answers

Not turning on


Hi -

We have two of these cameras. If it has been dropped, it can affect the way the camera "reads" the case sliding. Please turn the camera over and check on the bottom, and see where the cover is sliding to. If it is off track, it will not read it properly.

Also, rechargable batteries don't really work in this model worth a hoot. It is a power user. We've found only ONE kind of batteries that really make this camera work smoothly - the energizer "e" batteries in the silver and BLUE packaging. I take a LOT of pictures, and have had these last up to a month. (I am always curious about battery life and date them with a sharpie when I put them in.) Even after they no longer power the camera, they have plenty of oomph left for powering other regular items. (Our hair trimmers have been running for two months on AA taken out of the camera.)

Also, please close the slider a couple times and reopen it, making sure it is going all the way over. It doesn't always lock into place, and the camera mis-reads it as still being closed. It is a pain in the rump, and something I hope subsequent models get a modification on!

Also, simple, but double-check your batteries, and be sure they are not inserted backwards. Oftentimes, this is the reason ours won't turn on - in haste, we've put one or both in the wrong direction! Ha!

Hope that is the only problem for you.

Dec 23, 2007 | HP Photosmart M22 Digital Camera

1 Answer

Camera will not turn on.


it need to be opened by an specialist... it is sure there is nothing you can do for it without open it.

Sep 05, 2007 | Olympus Camedia D-360L Digital Camera

Not finding what you are looking for?
HP Photosmart 435 Digital Camera Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Digital Cameras Experts

Fred Sops

Level 2 Expert

271 Answers

teddyboy

Level 2 Expert

413 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you a HP Digital Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...