My canon camera after 4 to 5 picture is saying e32 and shut down then i have to start again

This is an Error message look on the Canon website for the list of error codes.

update firmware might help sounds as if you might want to get all the pictures off of it ect . bad products seem to be the norm these days

One of the most common causes of the E32 is that there is an issue with the lens alignment. It make be stuck in place. Does your lens work in and out when you power up and down your camera? If so, there may be a hardware error causing the issue. If you are fortunate enough to have an authorized Canon dealer/shop in our area, you could take it to them and let them look at it.

Otherwise, if there is a local camera shop or a camera club nearby, you could seek additional help there as well. As a last case scenario, you could take it to a Wolf Camera or Ritz Camera which is a big-box camera store if there is one nearby.

I am sorry to say that the only way this is going to stop is to have your camera repaired !!! It requires service and there is no way around it.

hi
your unit is fairly new product. you just send to canonUSA. it should cover by warranty.

From the Canon manual: "Error code E32 means the camera was dropped on concrete"

did you get a solution to this problem?

I have purchased recently canon ixus 130, the camera automatically shuts down after some 30 sec& shows a messege 'camera error,restart camera will autometically shut down error
E32.'

Its showing an error message. As its new take it back to the vendor and get them to sort it out, replace it or give you a refund. Its still under warranty, you don't want to void the warranty by messing about with it.

Just bought a Canon SX210, I can take only a couple of shots before the Camera gives Camera error E32 and shuts down, this is a consistent. Any hints?