Question about Car Speakers & Subwoofers

1 Answer

My battery ran down after installing cd player

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

You probably cross the wiring ensure that neg is with neg and pos with pos

Posted on Aug 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Remove cd player/2003 toyota avalon xls


hi,
please state the problem completely sir.What is it that you want to do?

Jul 19, 2011 | Car Speakers & Subwoofers

1 Answer

2005 Corolla cd player "ate"


try disconnecting the battery for a few minutes to reset the radio. Sometimes a microprocessor will lock up. You can reset it by disconnecting the battery.

Jun 01, 2011 | Car Speakers & Subwoofers

1 Answer

I hav a clarion auto cd/stereo displaying err 6 please explain, thank you


Error 1.Battery inside CD Changer needs to be replaced.
Error 2.CD error message. Mechanism has as eject problem or takes a long time to select CD.
Error 3.CD error message. The pick-up is out of focus during play mode due to scratches on the disc or contamination.
Error 4.Connection problem. Reconnect the data cable.
Error 5.CD error message. Could not read correct data due to CD ROM.
Error 6.CD error message. Could not read data from disc because it is upside-down.

For error code 6:
Try an original purchased cd with no scratches and see if the cd player reads it. If yes then lens is dirty or tired so try using a cleaning cd(has little brushes on it). If it doesn't read with the original cd try using the cleaning cd and if no go then look at purchasing a new cd player!

Nov 01, 2010 | Car Speakers & Subwoofers

1 Answer

I have a 2000 cadillac sls. Battery ran down, can't use radio&CD


Try disconnecting your battery for 10 minutes to reset the radio and factory amp. Disconnect negative terminal only and avoid touching your 8mm wrench to the positive post(s). Read the warnings on top of the battery about smoking and open flames and safety glasses too, or you can read the owner's manual and pull the radio memory fuse for 10 minutes.
-JMFT

Sep 30, 2009 | OEM Systems Car Speakers & Subwoofers

1 Answer

2001 Lexus LS430 6 Disk CD Player ''CD ERROR''


The sixth place is where the cd that was being played has to be put before it can take another cd to play. there should be a reset button some where im not sure where yet but I will find out and let you know shortly.

Aug 27, 2009 | Car Speakers & Subwoofers

1 Answer

AVIC-N1 Mechanism Error ON PIONEER CAR UNIT IS DISPLAYED ON THE SCREEN, IT WILL NOT EJECT A DISC. THIS OCCURRED AFTER THE BATTERY ON THE CAR RAN DOWN AND THEN THE CD DVD PLAYER WOULD NOT WORK PROPERLY.


If the battery was recharged by someone who accidenly reversed the leads then it can kill a radio, usually blows radio fuse first tho. Im affraid the unit needs repair from what youre saying.

May 15, 2009 | Car Speakers & Subwoofers

1 Answer

CD Player not workinig


Try using a cd player cleaner disk, then remove the radio fuse in the fuse block wait about five minutes then re-install. This is done to restart the radio. If that don't work disconnect the negative from the battery, wait five minutes then reattach, this will restart the cd player for sure. This will also restart the car computer just so you are aware.

May 12, 2009 | Car Speakers & Subwoofers

1 Answer

How to wire a kenwood kdc d300


All components on your Amplifier should be labled. Ground Will go to any ground on your Vehicle Ex. A bolt under your trunk floor cover. Power has to be ran from your positive terminal onto your batter and throught the interior of your car to your amps 12v +. The MEMORY TERMINAL IS NEEDED FOR FUNCION! It will be between Ground and POWER or NEXT TO POWER.. This has to be ran to your cd players BLUE MEMORY wire or you can bypass it directly to the POWER, WARNING!!! if you use the bypass method, put a switch that you can pick up from any autozone or such between the two points to shut off the amp, other wise it will run constatly and kill your battery. The two RCA's have to be plugged into the back of your cd player and ran back to your amp and plugged into the Primary Slot (red-white) and finnaly the +.- speaker wires need to be ran to your subwoofers. Once all conected pop in a cd, adjust your cd players bass settings and also adjust your lows, mids, and highs on the amp to fine tune your speakers. IF you are looking to maximize your speaker wattage, you can use the bridge teqnuiqe. But beware you are going to doubble the ammount of power into each speaker. Take both positives, or if only one speaker just the single possitive, and place it into the Right SPEAKER insert on the Amp, and take both negitives and place it into the LEFT SPEAKER insert, and run the wires like normal to each speaker, 1 wire per - one wire per positive, in doing so both speakers run using maximized power usage

Sep 11, 2008 | Kenwood Car Speakers & Subwoofers

Not finding what you are looking for?
Car Speakers & Subwoofers Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Speakers & Subwoofers Experts

xxxxxx xxx

Level 3 Expert

4706 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Car Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...