Can't close tape door on my sony handycam and get the re-attach to power source message even when it is already attached

Sony Handycam CCD-TRV58 Hi-8 Analog Camcorder
1. Per the manual on esupport.sony.com
- if the power is disconnected door won't open, and if the battery is the dead the door won't open.
Plug it in and hopefully you can get the tape out.

Did this work?

Before doing anything the numbers on this code tell you to clean camera and heads.
After it should all be fine.

Re-attach the power source message appear due to 2 reasons. 1.mechanical cable or flex damage & 2nd is Capstan motor is not working

my camcorder need to do re attach the powe source ,how can i fix it
thanks

apply a DC voltage of 5v to the tape motor at the bottom of the camcorder. you'll find two little semi-hemispheres on top of motor. trial and error to figure out which is positive.

same problem here. urg someone help us!

GO TO REPAIRING INTERNAL PROBLEM

It sounds like the tape door is out of alignment, causing stress on the tape and the inside mechanical system.  Requires a visit to the service shop.

Take the battery out and turn selection switch to camera and then turn it off. Put the battery back in and its working again.
if that doesn't work try
Try smacking the side of the camera relatively hard with the palm of your hand. Eject the tape and reinsert. You may need to do this a couple of times. good luck
please mark the post with a fixya

I had the same problem. First, depress the reset button, located on the camera body (where the LCD screen closes over it). It is hard to see at first. It is important that the camera be set to the OFF position. When the camera is whirring after the reset, then hit the EJECT button so the tape comes out. Take the tape out and insert it back. That's it. My camcorder worked fine and let me record or plaback once I followed those steps.

Vic