Question about Clarion VRX935VD Car DVD Player

Open Question

Clarion vrx935vd no sound in DVD,TV or CD modes help!!!

I have audio comming from the speakers in the tuner mode. I do not have any audio comming out of the speakers in DVD,TV or CD mode!! The audio these modes only comes on for about 2 seconds then stops. Does any one know why? I took it to a local radio shop and they could not help me.

Posted by on

  • Anonymous Nov 18, 2008

    the exact same thing

×

5 Suggested Answers

  • 216 Answers

SOURCE: help with install on clarion vrx935vd

Clapster is right on those steps.
Also, to check those speakers...try these steps:

Open your car speaker covers and pull out the speakers.
Once out, you can see which wires are connected to that speaker.
Writes them down, now do the other four.

First, you must disconnect the car battery when working on wires or removing the radio out or installing.

atdlee@netzero.com

Posted on Feb 25, 2008

mmorlan
  • 51 Answers

SOURCE: help with install on clarion vrx935vd

Depends on the type of car you have and everything, I think you should take it to a professional.

Posted on Apr 16, 2008

Benimur
  • 6966 Answers

SOURCE: wiering

Hi,

For a Clarion VRX935VD, installation and wiring information may be found here.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Posted on Sep 13, 2008

blueextc3221
  • 15935 Answers

SOURCE: wiring diagram

http://www.paperlessusa.com/MINI/MINI/Installs/DVD%20Clarion/Manuals/VRX935VD_Eng_Inst.pdf

manual

Posted on Dec 22, 2008

  • 1 Answer

SOURCE: My clarion vrx935vD doesn't come out.

simple thats because you must have forgot to plug the small adapter in the back of the deck that has a yellow and black wire coming from it. if you have then one of those two wires are not hooked up to the right place. and if that fails then either u have a bad connection somewhere in ur car wire or in the inside of ur deck. i had the same problem when i hooked up mine i just forgot to hook up that adapter because its really small

Posted on Jan 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just bought a car with this stereo. Was working fine and then I accidentally was messing around trying to figure things out and put it in demo mode. Now it's stuck!! Can someone please help?!?!


With the stereo on, hold the large round button in to get to setting menu. When it gets to that, I believe clock adjust comes up first, just turn the knob to get to demo mode and then push the button in. Turn the knob to switch demo off and then push it again. That should do it.

Jan 10, 2017 | Car Audio & Video

2 Answers

Sony mex-bt38uw


Is there a question here?

Jan 10, 2017 | Sony Car Audio & Video

1 Answer

I have a boss 400w riot 2-4 channels,how do i connect the high level wires? Because stereo doesn't have rca's


to use the high level leads, you have to isolate the wires going to each speaker (if using 4 channel mode) or isolate the wires going just to the rear if you are using 2 channel mode. you have to strip a small piece of the insulation off each speaker wire, and run it into the amps high level input harness. if you dont have the high level input harness, you can get a 2 channel high level to rca adapter for around $20. basically, you are tapping into the signal to the stock speakers to feed music to the amp. make sure you get all your positives and negatives correct. brighter wires are usually positive; however you may be faced with sa speaker which uses a grey wire, and another grey wire- the second with a black line. you will have to, again, turn to internet research to determine which is positive and negative, if the colors are not obvious.

Dec 30, 2016 | Boss Car Audio & Video

2 Answers

What do you think the problem is as to why my ipod want load up,i keep getting the message ipod communication aborted.


bad receiver in the radio, or, the transmitter on the ipod is bad. try it on another bluetooth source to see if it maintains connection, if not, the ipod could be damaged or bad. If it works with another bluetooth source unit, then the radio has a bluetooth receiver issue.

We sell low priced replacements!

http://advancedelectronic.net/

Nov 22, 2014 | Pyle PLDN74BTI Car Video Player

1 Answer

How do i program a clarion db158r car streo


Go here to download operator guide.http://www.clarion.com/gb/en/support/owners_manuals/select/D_H/index.html

May 26, 2014 | Car Audio & Video

2 Answers

How to on bluetooth


KD-R200 does not have the ability to add Bluetooth to it

Apr 03, 2014 | JVC KD-R200 Car CD/ MP3 Player

1 Answer

1992 GOLDWING RADIO SPEAKERS NOT WORKING


All you can do is trace the wiring back from the radio to the speakers, there is no quick fix here. To test the speakers touch a battery to the two contacts, the speaker will pop if it is any good.

Nov 06, 2012 | Car Audio & Video

3 Answers

No se como activar el bluetooth de jvc KD-G240


puxa el manual no me sirvio de muxo ya qe no dice nada sobre el bluetooth, pero en la radio sale un dibujito de la B de Bluetooth

ayudaa, plis!!

Jan 23, 2011 | JVC KD-G230 CD Player

Not finding what you are looking for?
Clarion VRX935VD Car DVD Player Logo

Related Topics:

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Clarion Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4766 Answers

yadayada
yadayada

Level 3 Expert

67930 Answers

Marco Avila
Marco Avila

Level 2 Expert

56 Answers

Are you a Clarion Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...