Question about Televison & Video

1 Answer

I have just got this nice shiny little number but i am having a few problems when i switch it off it is ok and the red light comes on but after around 3 mins the blue light comes and and the thing just beeps at me does anyone know why it does this ? not sure of the message on the screen as i do not have it connected to the tv yet ? regards chris

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Sweetheart, let me guess, your blond with big ****?

Posted on Oct 10, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Element on indicator light for frigidaire electric stove fell out. How do I fix it?

I know what you are talking about. It is the little light on the panel and it comes on to warn you if the element on the top of the cooking stove is hot. There is a little plastic red piece that pushed in the hole. The light you see clamps onto it. You have to pull out the oven and remove the shiny metal back from the oven. Make sure you unplug or turn off your power to the oven. You will need to buy a new red plastic piece. It is called a light lens.
light lens here

Jan 02, 2012 | Frigidaire GSX 1100 E Kitchen Ranges

1 Answer

Furnace will not respond to thermostat call for heat. Thermostat has been replaced with no effect. Have been informed it may thermocouple problem. Please advise. Thank you.

there's no thermocouple.there is many other safeties.hears what happens when you turn on;.1 draft inducer motor comes on. if all is ok with vent,then; 2 ignightor turns on .after a few seconds; 3 gas valve turns on if all limit switches and inducer switch are closed;.4 flame sensor checks for flame.after short delay fan comes on.if any safety switch is open theres no heat.look in little window and count red blinking light.theres a chart inside cover that will tell you whats wrong.some times theres water in tube going from draft inducer to diafram switch.the limits around fire box can be reset by pushing button in center.if theres no red light then low voltage transformer may be bad theres also a little fuse on board.if its blown you need to find out why.also any of these parts can go bad at any time.good luck

Dec 24, 2010 | Goodman GMS90703BXA Heater

1 Answer

I have a Cooper lighted 3-way switch. my house has 3 wires, a red a shiny black and a dull black. how do i install the switch?

You can't tell by the colors. The Hot wire comes from the panel to the first switch (that might be this switch or it might be the other one). The two Travelers go from one switch to the other switch. The output wire from the second switch goes to the light. So of your three wires - two are travelers and the other one is either the hot wire or the output wire. Here's how to determine which is which before you connect to the switch. Connect red to shiny with a wire nut and put a wire nut on dull (just to cover it). Turn on the power and operate the other switch. If the light will not light (in either position of the other switch), then your red and shiny are your travelers, your test is done. If the light DOES light, then dull is one of your travelers, so repeat the test connecting dull to shiny. If the light does not light, then dull and shiny are your travelers. If if DOES light, then dull and red are your travelers. ..... OK, now you found your travelers. On your switch you will have one terminal on top, and two on the bottom (or one on the bottom and two on the top) Connect your travelers to the two (on top or bottom) the other wire connects to the terminal that is alone on top or bottom. By the way, the only affect of interchanging the travelers is to make the light operate with both switches are in the same or opposite positions.
Good luck and merry Christmas Al K

Dec 23, 2010 | Cooper Wiring Devices "COOPER WIRING"...

1 Answer

When I leave the lights on in my 2001 hyundai elantra, I don't get that buzzing noise when I ope the driver side door. Also, the lights(both map light and driver side door lights) don't turn on when the...

the door switch is corroded - simplethe push button switch (that is pressed when you close the door) it comes out with a Philips screwdriver, undo the screw and pull out the switch it may be a bit stuck but wiggle it and it should pop out, when you look at it you'll know what I mean by "simple" - sand down the brass looking contacts till they're shiny and dab a spot of grease on there and refit the switch, all should be well again. - I quite like the elantra, nice and roomy :-)
Actually before you do this you can open the door with key in, lights on, so buzzer should be on and wiggle the little post that sticks out of the door switch, if you pull it out a little the buzzer should come on proving that the contacts are dirty and not connecting properly.

Jan 25, 2010 | 2001 Hyundai Elantra

1 Answer

The red laser pointer underneath the mouse isn't coming on? put new batteries in and the receiver is showing the green light once plugged into my laptop.

I doubt the problem is the battery. I have this same mouse and it has worked beautifully for two years now EXCEPT for one problem: most of the time, the mouse does not turn on when the receiver is removed from the receptacle on the bottom of the mouse. There is a tiny little switch built into that receptacle, along the side wall of the receptacle not far from the light. I have to wiggle this little switch (gently!) by hand a few times until the light comes on. From that point, the mouse will work fine until the receiver is placed back in the receptacle.

Dec 07, 2009 | Microsoft Wireless Notebook Optical Mouse...

1 Answer

Sony Trinitron KV-28LS36U no sound or picture, the standby light flashing green and red but if i switch it on a little bit of sound comes and then switches off. how can i repair?

The unit is shutting itself down because a problem was detected internally. When this happens, the standby light should blink a repeated pattern. Please count the number of blinks and post the number here. That will indicate the circuit in which the problem occurred.


May 19, 2009 | Sony Televison & Video

1 Answer

Changing the code on outside keypad of a Liftmaster model 7220.

push he little red or green button on the back of the operner and then within 30 sec. press the four numbers and enter on your keyless entry. the light on the opener should blink twice. Have a nice day once you hit this new 4 number code your old one is gone.

Mar 20, 2009 | liftmaster Chamberlain Garage Door Opener...

1 Answer

Little red light ,


Try taking out the battery for a few hours. The red light should turn off.

May 27, 2008 | Sony Ericsson K800i Cellular Phone

1 Answer

Red light when power is "ON"

no not at all you enjoy sound ok...

Nov 20, 2007 | Altec Lansing VS4121 Speaker

1 Answer

Runs for a second

your problem might be with the switch itself. remove the back of the unit. on the lower right side is the switch. with the bucket in place and the unit turned on play with the red or black wire. there might be an intermittent problem. if so look in the manual for the parts breakdown. it will list the part number for the switch. not hard to change. first remove the bucket,then go to the red button and remove the button. behind the button is a nut which holds the switch in place. remove the nut and the switch will come off from the back-----good luck

Aug 20, 2006 | Kenmore 54351 Dehumidifier

Not finding what you are looking for?

Open Questions:

Televison & Video Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75452 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Cindy Wells

Level 3 Expert

5423 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides