Question about Xerox XA7-172i 17" LCD Monitor

3 Answers

Reliysis jm777 the problem is that after approx 20 seconds the screen goes blank

Posted by on

  • 1 more comment 
  • sirrah1503 Oct 11, 2008

    my monitor is doing same thing, only stays on for a few seconds then goes black

  • tblackdawg Oct 15, 2008

    monitor comes on during start up, then goes black

  • trumillon Oct 21, 2008

    some technics saw my monitor says it look like twooption the video card that can't not hold the voltage of the screen or .lamps

    I can't find this twopart s of thsi monitor where I can Buy it ?.

    Leo Trujillo (Trumillon)

×

3 Answers

The problem is that after approx 20 seconds the screen goes blank

Posted on Oct 08, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Thanks very much for this information I am gonna try and I promise I will let you know if this work out.

Trumillon.

Posted on Oct 24, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Its the capasitors on the power supply

Posted on Oct 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Unit comes on,runs for ten seconds,(w sign on page on screen)then turns off.


"Hello, Sounds like you have a bad monitor, or video cable, replace."

Nov 08, 2015 | Computer Monitors

1 Answer

Monitor flickers and goes blank after 5 seconds and keep repeating this very often.


Hello,

If you turn the monitor off then about 1020 sec turn it back on and have a picture for five sec again it sound like the power supply in the monitor. but if that did not solve the problem, the picture board on your monitor is bad, since it goes off after few seconds and the power led or button is on, it means the picture board of your monitor has developed fault and will need to be replace.

I advice you replace the picture board on the screen of your monitor to solve the problem of the blank screen.

Take care.

Jul 26, 2010 | Acer AL2016W 20" LCD Monitor

1 Answer

HANNSpree monitor screen going blank. The screen dims after approximately 20 seconds and then 10 seconds later goes black. I still have a blue power LED. I have tried with two different machines running...


Sounds like either the inverter board is failing - or it may be the power to the inverter board. Look up your model# on eBay and you may get some insight as well as a source of parts.

Nov 14, 2009 | Computer Monitors

1 Answer

Screen goes blank after 3/4 seconds Monitor approx.1 year old


I can confirm the number 3 solution. I have fixed a bunch of these now.
Replace capacitor C202, 680uf 25V. It is usually visibly damaged. It should be a low impedance type, often known as "suitable for switch mode power supply".Even yesterday.

Nov 06, 2009 | ViewSonic Optiquest Q19wb LCD Monitor

1 Answer

I require monjitor drivers for a second hand


This MIGHT work:

http://www.nodevice.com/driver/company/Relisys.html

Just be careful.lol And you can find these sites by just typing it in in google.

Sep 22, 2009 | Computer Monitors

1 Answer

Screen Goes Blank


Ive seen this on other monitors. Look for a 1 and 2. Some monitors do NOT auto detect a signal, and this one might not. Look for a way to set the monitor from Digital input to VGA input. Try that and see.

Jul 21, 2009 | Dell E173FP 17" LCD Monitor

1 Answer

Screen goes bank after 2 seconds even if powder light is on


i just finished repairing a 20 inch acer monitor that had the same issue.... you have to take it apart and examine the power supply side of the monitor. there are capacitors that go bad on that board. you can tell be feeling the tops of them... the feel rounded. replace the capacitors and put it back together and it will work fine

Apr 16, 2009 | Computer Monitors

1 Answer

JM777 no receiving signal from CPU


when u power up the computer press F* key then go to enable vga mode then set disaply resolutin incotrol panel to 800*600 or 1024 *768

Nov 24, 2008 | Relisys TL 766 Monitor

1 Answer

Nec flat screen goes blank after 20 seconds


i got the same prob.supposedly its the cap(capacitor) ,the one for the power suppy near the cord input.im getting my shit fixxed.and i will let you know.

Sep 24, 2007 | NEC AccuSync LCD72VX LCD Monitor

Not finding what you are looking for?
Xerox XA7-172i 17" LCD Monitor Logo

Related Topics:

367 people viewed this question

Ask a Question

Usually answered in minutes!

Top Xerox Computer Monitors Experts

jeff5may32

Level 3 Expert

1203 Answers

b0b789

Level 1 Expert

9 Answers

Bob Sloan

Level 3 Expert

2013 Answers

Are you a Xerox Computer Monitor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...