Question about Philips Magnavox 51MP392H Rear Projection Television
Today our 10 year old Phillips Magnavox started having a blank border (2") along the vertical sides, whats up?
Sounds like a convergence chip problem...
here is my general post for the 51 inch you'll have to look at the link for the manual and check to see if you have the STK392-120 chips or somthing bigger in the 60"
you need 2 Convergence IC's STK392-120's (120's and 150's will work) of course order 2 of the same type I'm using replacement 150's they allow for a little higher heat and were cheaper ALSO you need to replace the 12 resistors with 6.8 ohm metal film resistors, make sure they are metal film! don’t skimp out here I did and then they blew and fried my IC's and I had to replace everything again!
Great reference link that I posted pictures on, check out page 3
Where I got my parts that worked:
Suburban Electronics http://www.suburban-elect.com/
Manual Library you should find all you need here:
What you need:
(2) STK392-120 OR STK392-150 IC chips
(12) 6.8 Ohm Metal Film resistors
set of star screw drivers
15 watt pencil solder pencil, DO NOT use a high watt iron you will fry the surface mounted item.
good leaded solder, and flux
Posted on Nov 20, 2008
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Feb 10, 2013 | Philips Televison & Video
Dec 13, 2010 | Philips Magnavox 60PP9701 60" Rear...
Jan 29, 2010 | Philips Magnavox 9P6034C 60" Rear...
Sep 20, 2009 | Philips Magnavox 9P6034C 60" Rear...
Nov 24, 2007 | Philips Magnavox 51MP392H Rear Projection...
116 people viewed this question
Usually answered in minutes!