I have a GE 1.5kw microwave model # JVM1630bk01. How do I replace the lamp?

The lamp is located inside the oven. You have to remove the outside cover to access the lamp asembly. You should be aware that removal of the cover exposes potentially dangerous voltages. With the cover removed, remove the old lamp and instal lthe replacement. Reinstall the outside cover.

The lamp is located inside your microwave oven. The outside enclosure has to be removed to access it. Beware of dangerous voltages exposed when the cover is removed.

Open the cover n you will see the bulb open it by turning it sideways

Lamp replacement requires some disassembly

Replacement of the lamp should be carried out by a qualified appliance repair service.

YOUR SAFETY IS PARAMOUNT!

Attempt this only if you are competent.

But here is a basic method if you are mechanically minded and have electrical safety knowledge.

The lamp is sat in a housing and its position is adjacent to the vent holes that it shines through.
If you feel confident, disconnect it from the mains power, remove anything in the cavity.
Remove the microwave cover. Purchasing a new replacement lamp will be useful as it will give you an idea of what it looks like. Locate the dead lamp remove the lamp and fit the new one. Replace the covers. Plug it back in and try the lamp by opening the door.
Hope this helps.

with cord unplugged you can remove the main control panel and access to it

PMG!!! I called GE and was told that changing the light bulb is not a consumer replaceable part!!! Are you kidding me!! She told me I had to have a GE tech come out. Makes you want to buy GE appliacnces, right!

Hello Diana,
Here is a link to the GE User manual for your microwave oven.. Once you download it.. You will find a section on light bulb replacement that details how to install and which particular bulbs to use..Hope this helps you..

http://genet.geappliances.com/DocSearch/pdf/49400821.PDF

Good Luck !

Should be able to get to the lamp by removing the grill.

Yes, Bobby, it can be done. Before you begin, though, go to Home Depot and look in the tool department. There, ask for a "Husky Pro #66604". It's a 1/4" and 5/16" drive 90 degree ratchet that's about 4 inches long. While you're there, pick up a #2 1/4" drive phillips screwdriver bit. You'll use both of these to do the light. Both for about $12. UNPLUG YOUR MICROWAVE! Stand on a small ladder in front of the Microwave (MW), remove the 2 screws that hold the vent louver in place and remove the louver. You'll now see a black plastic grill (just above the door handle)remove the 2 screws with your new tools and remove the grill and the metal box that covers the relay. Now remove the 2 screws holding the horizontal metal panel that the box was sitting on. Now gently lift that panel up, (don't try to remove it) and you'll see the lamp. It's the one with 2 white wires going to it and a shiny metal cover over it. Place your index finger on the back of the cover of the lamp and gently pull toward you and lift at the same time. This will release the catch and allow you to pull it all the way out to get to the lamp. There ya go! Simple!