Hi this monitor dont turn on.and the one of fuses on main board was broke i want to send me electronic design of sony pvm-9l2/5 monitor. thanks a lot.

You may be able to find the service manual for your Sony PVM-2541 by contacting Sony directly or by checking online electronics forums and websites that specialize in service manuals. Some websites may require a fee to access their service manuals. Here are a few options to consider:

1. Contact Sony: You can try contacting Sony directly and asking if they can provide you with a service manual for your model. You can reach them at 1-800-222-7669 or through their website.
2. Check online forums: There are many online forums and communities dedicated to electronics repair and service. You can try searching for your model on these forums to see if anyone has shared a service manual or can offer advice.
3. Search for service manual websites: There are websites that specialize in providing service manuals for a variety of electronic devices. Some of these sites require a fee to access their manuals, but they may have the specific manual you need. Be sure to read reviews and check the legitimacy of the site before making any purchases.

Please note that accessing service manuals can be risky and should only be done by experienced professionals with the necessary knowledge and tools. Incorrect repairs can be dangerous and can cause further damage to the device.

This might be a CRT base card fault. Replace the CRT connecting socket at this card. The fault technically called as 'one color predominant screen'. If you wish to get some more details about this kind of fault to CRT TVs, check this link. Pull up older posts there. One among these posts have detail descriptions.

Hi,
It sounds video processor is not getting voltage from sub power supply section on main board of camcorder that is why you do not get any video output in lcd or viewfinder in any mode.
I'm Sony camcorder tech and can help you if you are handy with electronics stuff repair and can take apart camcorder easily with proper tools.
In my opinion, there would be fuse blow out that provides volts to video signal section. Let me know exact model number of camcorder to proceed and if you feel uncomfortable working on camcorder then local camera repair shop is an option to get it fixed.
Hope these info will help you.
Thanks.

You may have bad backlight inverter circuits, lamp assemblies, power supply failed due to bad caps. Yes, there are fuse insdie for the inverter and the main fuse.
You need to open it up.post pictures if you can for details help.

http://s807.photobucket.com/home/budm/allalbums
Capacitors kit: http://lcdalternatives.auctivacommerce.com/
he can make you a set of caps for you.
http://en.wikipedia.org/wiki/Capacitor_plague

Try looking on 'www.eBay.com' -- although it may be cheaper to buy a new 17" monitor.

You have other issues than the remote if you can't turn the set on with the on button on the TV...could be the main board or power board

Hi!
If the camera shows the menu very dark too, could be a dead display backlight fuse. If you have experience with soldering and a multimeter, you can contact me at [email protected] and I can help you locate the fuse on the main board. Otherwise, contact your local Sony service center.

Tom

HI,
    The main board which called SY board being malfunctioning.And you have to replace the main board.For this plz contact nearest possible SONY SERVICE CENTRE.You didn't mension Model No. here so that i was able to give you the part number too.But anyway it will solve frm there easily.
 Thanks, And dont forget to rate.

hi my name is joel joely from etech vanuatu limited. my dell LCD monitor is just blinking power light on with orange light and also power switch not working if turn it on or off no display on screen.

my email address is [email protected]

thanks

joel

Good Day, problem on main board already, if fuses OK, disconnected the motors from lens assy, then promblem is already main MCB, per sony its level 3 problem, send board to BRC(board repair center) or change main board. thanks