Question about Kodak Easyshare M753 Digital Camera
Help from anyone please.
Darn Thing,only 2 weeks old.
When I turn it on, a Lens Error 115,1,0,0 is reported on the screen, the lens pops out OK, then the screen goes blank, the lens retracts and the camera turns off. Removing and replacing the battery deos not seem to work.
Any ideas anyone???
Thanks in advance.
SOURCE: KODAK M753 LENSE ERROR 122,1,0,0
I had this problem too, my camera just randomly stopped working and shut off. When I tried to turn it on again it said the whole 'lens error' bit and then shut of. The lens looked a bit crocked so I just gently tried to straighten it out and ta-da! Good as new!
Posted on Nov 03, 2008
SOURCE: camera focus error
there is a small logic circuit that controls the motor that retracts the lens and a sensor that tells it the lens is retracted, it is a lens position sensor, one of these two components is most likely defective, the thing is there are no consumer service info provided by panasonic, they will not sell you parts either, the camera is a mystery to take apart and repair without the tech manual which u can't get, so u see the delima here, u must either have this camera fixed by a panasonic repair station or see if it qualifies for a upgrade exchange program for a newer model.
Posted on Aug 07, 2009
The problem you describe is frequently the result of dirty/corroded
battery contacts in the camera. Try removing the batteries and
cleaning the inside contacts with a fine wire brush, steel wool, or
fine sandpaper. Remove any residue left from the cleaning, then
replace the batteries. Hopefully all will be well.
If the cleaning doesn't work you might want to check the Kodak troubleshooting guide at:
Posted on Aug 09, 2009
I had this very same problem, and I managed to fix it. In my case, this happened because a gear inside the lens housing was knocked loose. To gain access to it, you'll have to disassemble the camera and remove the lens assembly(the black cylinder that takes up half the camera). Unscrew everything, being careful not to damage any of the fragile ribbon cables. When you finally open it, the gear you are verifying is a tiny white gear that is under a small, silvery cylinder. This is the same silvery cylinder that sits aside the entire lens assembly. Make sure it is firmly locking teeth with the nearby black gear. If it isn't, carefully jiggle it while pushing it down, and it will lock teeth with it. Also, be careful to note where the spring is, as it must be present for the camera to work.
Best of Luck,
Posted on Aug 30, 2010
Tips for a great answer:
Oct 31, 2013 | Digital Cameras
Jan 26, 2013 | Kodak Easyshare M753 Digital Camera
Oct 09, 2010 | Digital Cameras
Oct 16, 2009 | Kodak Easyshare M753 Digital Camera
Nov 29, 2008 | Kodak Easyshare M753 Digital Camera
Sep 16, 2008 | Kodak Easyshare M753 Digital Camera
Feb 18, 2008 | Kodak Easyshare M753 Digital Camera
88 people viewed this question
Usually answered in minutes!