Please told me

Each window has its own motor and they are located inside the door so remove the inside door panel and then you should be able to check all wiring to the motors check with a test light to confirm power to motor if power is there continue to check the ground wire for proper connection! If all else fails you could always Google :)

hold up volume button and the power button to do a reset

If one tail light works, it's not the fuse box. It's either a ground wire off on that side , or a wire chafed along the curcuit. Your fuse for parking lights is for all four. If you have three, it's definately not the fuse box. You did not say what type of vehicle you have or I could have told you the best places to look for a ground wire. And I'd like to know if signal, brake, and reverse lights on that same side work at all. Let me know what your car is and we'll go from there. Please rate this solution thanks

its too simple, the main body of it is actually ground itself,,try to tie a wire or screw on body of it,, wish u luck

Not sure if you want to make a picture your back ground or get rid of one. But here is what to do. Right click any where on the desk top and chose properties chose change desk top back ground and find a new picture you want to make your background.

I have pictures Download in microsoft office 2007 i want to down load to facebook When I try to I get Unable to process this photo. Please check your photo's format and try again. We support these photo formats: JPG, GIF, PNG, and TIFF. Some Help Me

You didn't specify what make and model camera you have, so I'm going to assume it uses SD and/or SDHC cards.

SD and SDHC cards have a slide switch along one edge. The position farthest from the contacts locks the card, protecting it from writes. The position nearest the contacts unlocks the card. If the switch is already in the proper position, slide it fully the other way and then back again.

The store doesn't know what they are talking about. And I can't believe they told you to just keep switching wires. Hitting the wrong wires is an easy way to short the dimmer switch out. Take it back and go to Home Depot or Lowes and buy the same type switch you took out.

1. Remove the bolt from the kick start(where it attaches to the motor)
2. slide kicker off the shaft
3. move it forward a few shaft teeth
4. slide kicker back on
5. reinstall bolt

Well, whay dont you try that software what your dad told you.
One more software name is " File Scavenger" it also restore deleted files.